When did the Mazda RX8 rotary engine come out?
Mazda introduced the RX-8 in 2003 and put that rotary engine back into circulation within the car market once again. Buyers purchased this compact, cute and stylish family coupe Rx8, with details such as rear-hinged back doors and sleek bodywork.
Why does my 2004 Mazda RX 8 not start?
“Owner dropped 2004 Mazda RX-8 to the dealer to fix recall, driver and passenger air bag, voluntary emission recall, and also owner complains that the engine won’t start when the engine is hot, you have wait for about 30 minutes to cool down the engine before the engine starts again. Advisor asked the owner to have the engine diagnose.
Why is my Mazda RX8 rotary engine burning oil?
More than not, you will have to check your oil levels, and ensure you’re running a sufficient amount of oil. Perhaps this is the biggest problem with the rotary engine. With this engine you are burning significant amounts of oil, while it is also a challenge to seal off the different chambers.
How do you warm up a Mazda RX8 engine?
You need to warm up the engine slowly, stay in low revs depending on outside temperature for at least 20 minutes. Beware you need to warm up the oil, and the gauge on your dash is the water temperature, which heats up a lot faster! After that, drive it like you stole it.
Why does my Mazda RX-8 engine not start?
At the time it sounded like the battery, because engine turned very slowly. Since, I’ve changed battery, checked all fuses, and engine still doesn’t start (though it engine turns fine). Would you please assist me with any info which will help me to determine what’s wrong.
What kind of engine can I put in a Mazda RX-8?
There’s actually a lot of interest for a 6-cylinder powered Mazda RX-8. Narrow angle V6s can be installed and tucked away neatly within the RX-8’s motor compartment. Perhaps most intriguing, is the LFX swap, a 3.5-litre 54-degree V6 found in many Cadillacs.
What should I do if my Mazda RX-8 stall?
Try puting your car in neutral at the light – the vibration should stop or be barely noticeable. Mazda had a regional rep come out to look at my car, and his solution was to give me my 7th set of motor mounts. The vibration was a little better for about 10 feet, then it was back and worse than ever.
Can a 4 cylinder engine be swapped into an RX-8?
However, not every garage wall cabinet contains replacement parts for this engines so if you’ll break any of them you will get in trouble. Four cylinders are also swapped into the RX-8. The renowned SR20DET is a popular choice for the RX-8. People have even swapped other rotaries into the RX-8, either from the RX-7, or a custom made 3-rotor.