How do you reset the code on a 2004 Jeep Liberty?
How to Clear Engine Codes for a Jeep Liberty
- Open the driver’s side door of the Jeep Liberty and locate the diagnostic link connector (DLC) under the dash.
- Plug the pocket scanner into the DLC and then turn the ignition key to the accessory position.
- Read the onscreen menu of the scanner.
- Choose “Erase” as an option.
How do I reset my Jeep Liberty?
How to Reset Perform Maintenance on a Jeep Liberty
- Turn on the engine.
- On the vehicle’s dash, press the “Step” button until “Miles to Service” is displayed.
- Press and hold the “Reset” button, near the “Step” button, until the “Miles to Service” flashes and resets. Verify the “Perform Service” light goes away.
Where is the TCM located on a 2004 Jeep Liberty?
The 2004 jeep liberty transmission control module is located on the top of the transmission housing.
Do Jeep Liberty’s have transmission problems?
Even though this midsize SUV was given some fairly reliable engines at the factory, many owners do you report having problems with their 42RLE transmission. The most common of these Jeep liberty transmission problems is slipping between gears, or a noticeable delay between shifts.
How do I reset my 2003 Jeep Liberty?
Turn the ignition to run (one position before starting engine). Fully depress the accelerator pedal slowly three times within 10 seconds. Turn the ignition off and then start the engine to verify the indicator has been reset.
How do I reset my Jeep ECU?
Jeep Wrangler JK: How to Reset Your ECU
- Step 1 – Remove the positive (red) battery cable.
- Step 2 – Ground the red cable to the negative terminal.
- Step 3 – Reconnect the positive battery cable.
- Step 4 – Turn on your Jeep.
- Step 5 – Cycle the headlights.
- Step 6 – Turn the key off and remove.
Where is the transmission control module on a 2003 Jeep Liberty?
This is mounted under the hood on the passenger side of the engine compartment.
Where is the TCM on a 2006 Jeep Liberty?
The transmission control module of a 2006 Jeep Liberty is located inside the car, below the dash, and on the right side of the steering column. It is essentially a computer-like device used to control the transmission.
How much does it cost to replace a Jeep Liberty transmission?
The cost of your Jeep transmission repair or rebuild will depend on which parts need to be replaced and how many service hours the project will require. However, the average transmission replacement cost starts at about $1,800 and can cost as much as $3,400.
How to reset Jeep Liberty check engine code?
Tighten the bolt on the negative cable using the adjustable wrench until the cable end is tight and does not move on the post. Start the engine to ensure that the “check engine” light is no longer illuminated. Marc Lucas has worked in the education publishing industry since 2000.
What does the transmission code mean on a Jeep Liberty?
I’m what you’re looking for.” The code will trigger the service engine soon light and may put the vehicle into limp mode. If your vehicle has gone into limp mode, it won’t come back out until the computer detects in the Liberty that everything is operating within normal specifications.
When did Jeep Liberty start using OBD II?
Manufactured in 2002, the Jeep Liberty has always integrated the second phase of on-board diagnostics (OBD II). This newer vehicle diagnostic system standardized the placement of the data link connector (DLC) and the diagnostic trouble codes (DTCs).
What does trouble code p0700 mean on Jeep Liberty?
P0700 Jeep Liberty. September 29, 2018. One of the most common problems with the Jeep Liberty is when it throws the P0700 trouble code. A trouble code is a code thrown out by an automatic transmission whenever it detects in the Liberty that there is an issue that needs your attention. P0700: Transmission Control System Malfunction.