Does a 2004 Mercury Mountaineer have a chip key?
Like most late model vehicles, this 2004 Mercury Mountaineer key has a transponder chip, part of your automobile security system, in the head of the key. This transponder key has a circuit, chip hidden inside the head of the key.
How to program Mercury keyless entry key fob?
How to Program Mercury keyless remote keyfob. 3) Within 20 seconds, press any button on 1st car remote transmitter. Door locks will cycle to confirm remote programming. 4) Within 20 seconds, press any button on 2nd transmitter (up to 4 transmitters total possible). You have to press a button on every remote you have,…
What to do if your Mercury Mountaineer won’t start?
If your Mountaineer still will not start, and the flashing red light begins blinking rapidly when you attempt to start it, something is obviously malfunctioning. Either have the key reprogrammed or have more extensive troubleshooting and repairs done to the P.A.T.S. system by a certified technician.
How do you reset the P.A.T.s on a Mercury Mountaineer?
Either way, you must reset it before you can operate the Mountaineer. Unlock the door and insert the programmed key into the ignition and start the Mountaineer. In most cases this will reset the P.A.T.S. system and allow you to drive away. In the event it does not, move on to Step 2.
How to reset an anti theft system for a Mercury Mountaineer?
At that time, the little red light should return to blinking at the slower, passive rate. If, once again, the Mountaineer fails to start, continue to Step 3. Raise the hood and use the battery terminal wrench, or a standard box wrench, to remove the negative battery cable. Wait 15 minutes before reconnecting the cable, then repeat Step 1.
How to relearn Ford ignition key code program?
Select “Ignition Key Code Program.” Disconnect Tool and leave key in RUN for 20 seconds. 1 key required. Cycle key 1 to RUN, then OFF. Cycle new key to RUN. 2 keys required. Cycle key 1 to RUN, then OFF. Cycle key 2 to RUN, then OFF. Cycle new key to RUN.
If your Mountaineer still will not start, and the flashing red light begins blinking rapidly when you attempt to start it, something is obviously malfunctioning. Either have the key reprogrammed or have more extensive troubleshooting and repairs done to the P.A.T.S. system by a certified technician.
Either way, you must reset it before you can operate the Mountaineer. Unlock the door and insert the programmed key into the ignition and start the Mountaineer. In most cases this will reset the P.A.T.S. system and allow you to drive away. In the event it does not, move on to Step 2.
At that time, the little red light should return to blinking at the slower, passive rate. If, once again, the Mountaineer fails to start, continue to Step 3. Raise the hood and use the battery terminal wrench, or a standard box wrench, to remove the negative battery cable. Wait 15 minutes before reconnecting the cable, then repeat Step 1.