Why is my convertible top not moving up?
While the pump is running, the hydraulic system has air trapped in the lines. Also, this system has a major hydraulic fluid leak, and for that reason, the level drops below the MIN mark as the level drops, the convertible struggles to move up and down. Check the operation of the convertible pump motor.
Why is Max not marked on convertible top?
MAX, in some cases, is not marked because it is the same as the fill hole. You can’t fill them past the filler hole since the fluid will leak out, which is by design. Suppose the fluid level is too low the convertible pump operation completely to protect the motor and the hydraulic system components.
Where is the top motor on a convertible?
If the level drops below the MIN, the convertible top will either not operate at all or move too slowly, not close, or stop halfway. Locate the convertible top motor. In most convertibles, it is located in the trunk behind the lining. Also, check near the spare tire or behind the rear seats.
How can I tell if my convertible top is leaking?
You can visually inspect all the cylinders for leaks by manually opening and closing the convertible. At first, the leaks will be minor, but they will worsen over time, and you will eventually see leaks on the trunk floor or a stained convertible top.
While the pump is running, the hydraulic system has air trapped in the lines. Also, this system has a major hydraulic fluid leak, and for that reason, the level drops below the MIN mark as the level drops, the convertible struggles to move up and down. Check the operation of the convertible pump motor.
MAX, in some cases, is not marked because it is the same as the fill hole. You can’t fill them past the filler hole since the fluid will leak out, which is by design. Suppose the fluid level is too low the convertible pump operation completely to protect the motor and the hydraulic system components.
Are there any drawbacks to moving to the west?
That’s why many local governments have adopted a new “Code of the West” officially warning any paradise-seeking immigrants of the problems they’ll encounter when they move in, such as – egads! – rough roads, dangerous wildfires and the aroma of cattle. The hyped-up Top 10 lists don’t admit the drawbacks of my town.
If the level drops below the MIN, the convertible top will either not operate at all or move too slowly, not close, or stop halfway. Locate the convertible top motor. In most convertibles, it is located in the trunk behind the lining. Also, check near the spare tire or behind the rear seats.
What causes a Porsche Carrera convertible top to fail?
Another part of the system that can fail is the front latch mechanism on the center front of the convertible top. This motor assembly extends a hook out that latches the top against the windshield frame. If the motor inside fails, you can still manually open or close the latch.
Where is the latch on a Porsche Carrera convertible?
To open or close the latch, insert the 6mm hex key into the over-ride actuator and turn it counter-clockwise to close the latch (this is the same tool used to emergency open/close the entire top, located behind the rear seat panel) Turning it clockwise opens the latch.
What to do if you have a convertible top problem?
To troubleshoot your convertible top problem, we assume you already know how to locate and check fuses, relays, convertible top components such as lift cylinders, convertible modules, and pumps.
How many volts does a convertible top need?
Every time you press the convertible switch, you should read between 11-13 volts at the pump. If you are not getting any current at the hydraulic motor, you may have an electrical problem or a defective switch. There are between 4 and 10 micro-switches installed in your convertible required to run your top.
What to do if your Mercedes convertible is not working?
Check the convertible top relay as well. Swap it with a known working relay that is identical. You can also bridge the top relay for a couple of seconds to see if the hydraulic pump start to run. Replace the convertible top relay if necessary, PN 0025421319. Next, check the micro switch where the divider locks.
Why is my convertible top not working properly?
Check cylinders for fluid leaks. Another common reason why convertible tops fail to operate is due to leaks at convertible lift cylinders. The hydraulic cylinders move the hardtop or soft-top up and down. They have seals and o-rings that shrink and crack due to age.
When does a G37 Convertible hard top stop working?
2009-2013 G37 Convertible (V36) 2014-2015 Q60 Convertible (V36) SERVICE INFORMATION If the battery becomes disconnected or discharged while the retractable hard top is in any position other than fully closed or fully retracted, the retractable hard top control may stop operating and the following DTCs will be stored: B1707 and B1708.
Is the Q60 a retractable hard top car?
G37 AND Q60 CONVERTIBLES; RETRACTABLE HARD TOP INITIALIZATION SERVICE INFORMATION APPLIED VEHICLES: 2009-2013 G37 Convertible (V36) 2014-2015 Q60 Convertible (V36) SERVICE INFORMATION
What to do if your Mercedes convertible goes down?
If the windows don’t go down, make sure the trunk compartment divider is pulled out. Next, check the fuse for the convertible top. This is usally a 40 A fuse. If it is blown, replace it with a new fuse with the same ampere rating.
Every time you press the convertible switch, you should read between 11-13 volts at the pump. If you are not getting any current at the hydraulic motor, you may have an electrical problem or a defective switch. There are between 4 and 10 micro-switches installed in your convertible required to run your top.
Where is the fuse on a convertible top?
Locate the fuse box and look for the convertible top fuse. Depending on the model, the fuse box is located on the dashboard’s side or under the hood in the engine compartment. Pull the convertible top fuse. If the fuse is blown, replace it and check if your convertible will operate normally. If the fuse is ok, check the relay.
What to do when your convertible top stops working?
By the time your convertible top stops working, the leaks should be easy to identify. Inspect the hydraulic lines. Make sure they are tightly connected. The hoses should not be cracked or leaking. Address any leaks that you may find at the pump, cylinders, or solenoid. Replace any damaged or leaking o-rings.
Locate the fuse box and look for the convertible top fuse. Depending on the model, the fuse box is located on the dashboard’s side or under the hood in the engine compartment. Pull the convertible top fuse. If the fuse is blown, replace it and check if your convertible will operate normally. If the fuse is ok, check the relay.
Is there a way to fix a convertible top motor?
This method will fix most convertible top motors when your top is having a hard time going back up. This repair was on a 2000 mustang. This video is how I repaired my convertible top motor and I hold no responsibilities for you using my method of repair. Loading…
Why does my Mini convertible top not work?
2) The second part of the ops process did not start. The sunroof part of the convertible was difficult to open/close, and the motor created an awful noise when operating it. Reason: Because of lack of lubrication on the sliders, the electro motor driving the sunroof will get hurt. Solution: I purchased a new motor from “Roof Motors” in UK.
Why does my Mercedes convertible not go up or down?
Mercedes Convertible Top Won’t go up or down. Convertible top moves very slow. This can be caused by low fluid level or air in the hydraulic lines. Air in the hydrauilc lift cylinders. It can be caused by binding of mechanical arms. Weak convertible top lift cylinder. Weak battery or ground connection.
This method will fix most convertible top motors when your top is having a hard time going back up. This repair was on a 2000 mustang. This video is how I repaired my convertible top motor and I hold no responsibilities for you using my method of repair. Loading…
What are the most common convertible top problems?
Let us go over the list of most common convertible top problems: 1 Low Hydraulic Fluid Level 2 Failed convertible top pump/motor 3 Broken or bend top armor cable 4 The low fluid level in the top pump reservoir 5 Poor Ground Connection 6 Air in the System 7 Weak Cylinders 8 Defective micro-switches More
Why is my convertible top not working on my Mercedes SL500?
Start the vehicle’s engine, and let the car run while you open or close the hardtop. The hardtop does not operate if the car’s battery voltage is too low. Wait 10 minutes before trying to operate the hardtop again.
What to do if your Mercedes convertible top is blown?
If it is blown, replace it with a new fuse with the same ampere rating. Check the convertible top relay as well. Swap it with a known working relay that is identical. You can also bridge the top relay for a couple of seconds to see if the hydraulic pump start to run. Replace the convertible top relay if necessary, PN 0025421319.