What is the ABS code on a 2003 Mercury Mountaineer?
If you own a 2003 Mercury Mountaineer 4.0L, FLEX, Vin K and have Anti-lock Brake System (ABS) light on and trouble codes C1145 or C1234, you may have a bad connection at the wheel speed sensor. Start by inspecting the Right Front (RF) wheel speed sensor connections for physical
Where to find Mercury check engine light codes?
When retrieving Mercury check engine light codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.
Where can I find the Mercury diagnostic code?
Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s). Remember, these are manufacturer specific codes only. Refer to our Generic OBD II code list for definitions on all other Mercury diagnostic trouble codes. Manufacturer Specific Codes P1000OBD System Readiness Test Not Complete
What do you need to know about mercury fault codes?
Water pressure in the cooling system is low. Water pump may be faulty. Non‑Critical ‑ Service engine soon. Compressor is overheating. Check for plugged water inlet. Water pump may be faulty. before next use. properly. before next use. properly. before next use. Engine Guardian is active. Power will be limited to prevent engine damage.
If you own a 2003 Mercury Mountaineer 4.0L, FLEX, Vin K and have Anti-lock Brake System (ABS) light on and trouble codes C1145 or C1234, you may have a bad connection at the wheel speed sensor. Start by inspecting the Right Front (RF) wheel speed sensor connections for physical
How to find the Mercury check engine code?
Mercury Check Engine Light Codes 1 Refer to our Generic OBD II code list for definitions on all other Mercury diagnostic trouble codes. 2 Manufacturer Specific Codes 3 P1000 4 P1001 5 P1039 6 P1051 7 P1100 8 P1101 9 P1105 10 P1106
Where to find the serial number on a Mercury outboard?
You can find your Mercury outboard serial number and model number on an ID tag on the mounting bracket, or in some cases on an engine block freeze plug. See below for a Model Number Description Guide and Serial Number to Year chart. Extra long shaft (25″/635mm) driveshaft housing.
How to activate Mercury Marine SmartCraft engine Guardian system?
Oil lever is low in the engine mounted oil reservoir. Refill the engine mounted oil reservoir along with the remote oil tank. Refer to Fuel & Oil. Water in the water separating fuel filter reaches the full level. Water can be removed from the filter. Refer to Maintenance – Fuel System for filter removal. Engine Guardian System is activated.