Should you replace chain when replacing sprocket?
However, when you replace your chain, it’s a great idea to replace your sprocket at the same time. According to Motorcycle News, worn sprockets with new chains cause quick deterioration on both the sprocket and the chain. Eventually, you will find yourself replacing your chain quite often and see wear in the same spot.
Can I put a new chain on old sprockets?
It’s generally true, yes. However, in practice, you’ll find that the front sprocket wears much faster than the rear (because it has about one-third the number of teeth), and replacing the front sprocket every chain change and the rear every two changes is perfectly feasible.
How is chain sprocket damaged?
The sprocket has to be nasty to hurt the chain. The main thing is that the teeth will eventually break off and strand you/chain come off. The opposite, however, is true. A lousy chain will ruin new sprockets in short order.
Is it OK to replace the rear sprocket at the same time?
Your chain and sprockets will wear together over time, which is why it’s a good idea to replace the chain and sprockets all at once. Installing an old chain on new sprockets, and vice versa, will cause premature wear. Need help deciding between standard and X-ring chain? Click here.
Can a spacer be removed from the sprocket?
Spacers love to fall to the ground and pick up dirt. Make sure you remove the rear wheel after loosening the countershaft sprocket bolt/nut. Support the rear wheel so that the brake disk does not contact the ground. The brake disk can easily distort if the wheel is accidentally loaded when working on the sprocket.
What should I do when replacing my countershaft sprocket?
When installing the new sprockets, get all the bolts and nuts started by hand, then tighten and torque in a criss-cross pattern to prevent warping and uneven stress. Anytime new sprockets are installed, the chain tension and alignment should be checked.
How can I loosen the rear brake sprocket?
When working on a machine that uses a nut or bolt to secure the sprocket to the shaft locking the shaft is imperative to loosening it. There are a handful of ways the sprocket can be secured. The rear brake – With the chain still attached, have a helper apply the rear brake and loosen the fastener.
How to tell when chain and sprockets need to be replaced?
Another, much easier way to check for a worn chain is to try to pull the chain away from the rear of the sprocket on the rear wheel. If the chain is worn, you’ll reveal about half a tooth of the sprocket. A new chain will wrap around the sprocket snugly and won’t pull away.
Do you need a bigger sprocket for a chain saw?
The tradeoff is you’ll lose some acceleration. Going the other way will increase acceleration. If you fit a larger sprocket to either end, just make sure you have enough clearance. In any case, you can always use the stock sprocket sizes when buying new ones.
Can a larger sprocket be used on a motorcycle?
Going the other way will increase acceleration. If you fit a larger sprocket to either end, just make sure you have enough clearance. In any case, you can always use the stock sprocket sizes when buying new ones. While you’re doing this job, your motorcycle may have some other components you should check.
How much does it cost to replace a chain on a motorcycle?
If you do need to replace both sprockets and the chain, what’s it going to cost you? It really depends on the motorcycle you’re working on. Chains can range in price from $20 for a plain chain for a small, lightweight motorcycle to over $200 for something like a quality O-ring chain for a bigger, more powerful bike.