How much does it cost to replace a transfer case on a Jeep Wrangler?
The average cost for a Jeep Wrangler transfer case output shaft oil seal replacement is between $121 and $145. Labor costs are estimated between $91 and $115 while parts are priced at $30. This range is based on the number and age of Jeep Wrangler’s on the road.
What kind of transfer case does a Jeep Grand Cherokee use?
Since 1988, the NP231 has been the “Command Trac” transfer case used in the XJ Cherokee, MJ Comanche, and YJ Wrangler. It has been the “Command Trac” transfer case in the ZJ Grand Cherokee since its introduction.
What kind of lubricant is in a Jeep transfer case?
Drive Positions and Shift Controls: 2H, 4H, 4L and Neutral. Ranges selected via floor mounted shift lever. 4H and 4L ranges are undifferentiated. Case Configuration: One piece cast iron with aluminum front/rear bearing caps. Lubricant Capacity and Type: 4 pints (1.9 liters) SAE 85W-90 gear lubricant API grade GL-5.
What kind of case does a jeep NP200 have?
The NP200 was used in the Military WC 61-63. It is a 6×6 Tcase with 3 Outputshafts and a drumbrake on the Straight rear output. It is gear driven and bullet proof. “The NP 207 is one of the weaker Jeep transfer cases, but can be upgraded. The NP 207 has an aluminum case and chain driven planetary reduction.
Can a transfer case be built by New Process Gear?
Any transfer case that was built by New Process Gear will be included in the New Venture transfer case line for pur- poses of this article. One of the greatest problems fac- ing the transmission rebuilder and parts suppliers in the last decade or so is the tremendous proliferation of new units.
Where is the transfer case on a Jeep Wrangler TJ?
Most factory-built Jeep Wrangler TJs come complete with transfer cases inside the cab of the vehicle. In order to prevent gear binding, it may be necessary to shift into neutral before selecting either two or four-wheel drive.
What kind of transmission does a 1999 Jeep transfer case use?
The best bet is to stick with same model, year, and transmission unless you are prepared to swap the input shaft. From what I can find, the 1999 XJ used an AX15 transmission and the transfer case had a 23 spline short input shaft.
What’s the stock rotation on a Jeep transfer case?
The New Process transfer cases used in late model Jeeps are always a left-hand drop configuration. The stock rotation on the New Process transfer case depends on the year of the vehicle and the stock transmission used. The rotations are approximately 13 or 23 degrees.
When was the Jeep NP242 transfer case introduced?
The Jeep NP242 transfer case was introduced in the 1987 model year as a replacement for the NP228. The 242 premiered in the XJ Cherokee / Wagoneer and MJ Commache as the SelecTrac option.