How do I reset my Cisco 1800 series router?

How do I reset my Cisco 1800 series router?

How to Factory Reset 1800 series Cisco router

1. Connect you PC to the router via console cable and connect using Putty.
2. Boot the router while holding ctrl and break get into rommon1>
3. Type the following command.
4. Type Reset to start the factory reset.
5. To enter config mode, issue the config terminal command.

How do I check my router configuration?

Type ipconfig in the command prompt and press Enter to run the command. Scroll through the information until you see a setting for Default Gateway under Ethernet adapter or Wireless LAN adapter. That’s your router, and the number next to it is your router’s IP address.

What is the Cisco router IP address for configuration?

Open any web browser and type in 192.168. 1.1 in the address bar. This should be the default Cisco router IP address and will take you to your Cisco router login page.

How do I reformat a Cisco router?

Reset Router Using Reset Button

1. With the router powered off, connect the power cord to your router, and plug the power cord into your power source.
2. Find the Reset button on the router.
3. Press and hold the Reset button while you power on the router.
4. Release the Reset button after 10 seconds.

How do I Reset my Cisco router to factory settings?

1. Prepare the router. Make sure the Cisco router is turned off and the power cord is plugged into both the router and the power source.
2. Locate the reset button. Look for the small factory reset button on the back of the router.
3. Use the reset button.
4. Wait for the reset to complete.

What’s the first step in configuring a Cisco router?

The first step is to secure your access to the router by configuring a global secret password and also passwords for Telnet or Console as needed. In Global Configuration Mode you configure parameters that affect the whole router device.

When to enter ROMMON mode on Cisco router?

Router will enter in setup mode only if it fails to load a valid running configuration. Router will enter in ROMMON mode only if it fails to load a valid IOS image file. You can manually enter in ROMMON mode for diagnostics purpose. Enter in global configuration mode to execute following commands. By default Router name is configured on routers.

How to reload Cisco router in privileged mode?

Enter reload command from privileged exec mode. Press CTRL + C key combination during the first 60 seconds of booting process Use exit command. IOS commands are not case sensitive; you can enter them in uppercase, lowercase, or mixed case. Password is case sensitive.

Can you use a real Cisco router in a simulator?

You can use any network simulator software or can use a real Cisco router to follow this guide. There is no difference in output as long as your selected software contains the commands explained in this tutorial. Create a practice lab as shown in following figure or download this pre-created practice lab and load in packet tracer