How do I remove the passenger side panel?
Start by removing the window and power lock control panel. Pry it off with a screwdriver and then unplug the wires from it. Use a screwdriver to remove any screws holding the panel to the door. Grab the panel with both hands and pull it straight out to remove it.
How do you replace a wooden door panel?
With the proper tools and know-how, this is a job any do-it-yourselfer can manage in an afternoon.
- Remove the door from its frame.
- Remove any fasteners in the corner of the panel with a small pry par.
- Slide the panel out of the channel grooves.
- Insert the new door panel.
How do you take a door panel out of a car?
Pry against the metal portion of the door until you feel the fasteners pop. Move the tool towards the hinge area and repeat while holding the loose portion away from the door. Once the bottom fasteners are released, you can usually pull the door panel out and the remaining fasteners will pop out.
What’s the best way to remove a door trim?
Use the trim removal tool (next page) to pry the plastic trim off. Disconnect the electrical connector to the speaker. Don’t forget to check under reflectors and along the latch side of the door panel. the door trim panel can be removed. Look for a screw like the one shown in this illustration.
How do you reassemble a car door handle?
When you reassemble the crank handle, remember to install the clip so the open end faces the rotating knob. With the clip installed in the groove, simply press the crank assembly onto the splined shaft until the clip snaps into the shaft groove. This step requires some detective work and a small pick.
How does a Ricks door trim panel work?
The head locks into a keyhole slot on the door trim panel and the barbed “limb ends” are designed to push into a pre-punched hole in the metal door. During installation, the assembler simply hooks the top of the door trim panel on the window ledge and presses the panel against the door frame.