How do I get rid of C clip eliminator?
Just rotate the axle, remove the bolt, remove the 1″ pin, push the axle in, the clip will probably fall out. Don’t move the ring gear after pulling the pin or the spyder gears will fall out.
How do you remove C-clips from axles?
Line the pin up with the very edge of the opening in the axle housing so the 7mm bolt will just come out without contacting the housing. Remove the bolt holding the pinion pin in. Remove the pinion pin. Push the drive axles in as far as they will go. Remove the C-clips from the axles through the center of the carrier.
How do you remove a drive axle from a truck?
Remove the bolt holding the pinion pin in. Remove the pinion pin. Push the drive axles in as far as they will go. Remove the C-clips from the axles through the center of the carrier. Use the needle nose pliers and just lift them off. Once they are off, pull both axles out of the housing and stand them up.
How do you remove a rear axle cover?
Put the drip pan under the axle housing rear cover. Remove the rear axle cover with a 13mm socket. Rotate the carrier until the pinion pin side with the 7mm bolt is facing down. Line the pin up with the very edge of the opening in the axle housing so the 7mm bolt will just come out without contacting the housing.
How do you take a 7mm bolt out of an axle?
Line the pin up with the very edge of the opening in the axle housing so the 7mm bolt will just come out without contacting the housing. Remove the bolt holding the pinion pin in. Remove the pinion pin.
How to remove rear axle shafts with locking differential?
On axles WITH a locking differential, keep the pinion shaft partially withdrawn. 16. On axles WITH a locking differential, place the C-lock (1) on the axle shaft (3) so that the ends are flush with the thrust block (2) (Illistation # 8).
How to remove pinion seal from Chevy differential?
Pinion Yoke Removal 1 Remove Pinion Nut A fair amount of torque is required for removing the pinion nut. 2 Remove Yoke A few blows with a soft hammer usually gets the yoke free from the splines. 3 Remove Pinion Seal (Special Tool)
What’s the best way to disassemble a Chevy differential?
It depends on your preference and tools available. The first step is to use a socket and ratchet or a wrench to remove the cover bolts. Use a soft mallet to break the seal or use a pry bar, but be careful not to damage the mounting surface of the center section.
How to remove E clips without an E-Clip tool?
You can see them here: http://www.instructables.com/member/Yonatan24 If you’d like to contact me for sponsorship/collaboration/busines inquiries, please use the email below. All emails are read. Sick with a deadly disease called DIY-itis! How to Take Apart Speakers and Get FREE MAGNETS FAST! An error occurred while retrieving sharing information.