Where does terminal 30 connect to the ASD relay?
The rest of the circuit is not being supplied with power. When the fuel pump and automatic shutdown relay are powered by the powertrain control module (PCM), terminal number 30 connects to terminal 87 in an on position. Voltage is being supplied to the remaining part of the circuit by terminal number 87.
Where is terminal 30 on a fuel pump relay?
Potentially causing an (ASD) ground control wire to break between the (PCM) and the fuse panel. Terminal number 30 is connected to battery voltage. For both the (ASD) and fuel pump relays, terminal 30 is connected to battery voltage at all times.
Where is the ASD relay on a jeep?
In their wisdom, Chrysler placed the ASD relay below the battery and behind the driver’s side headlight. Over time, corrosion can rot out the wires to the ASD relay socket.
How does the auto shutdown relay work on a jeep?
When you turn the key, the PCM/BCM anti-theft system determines whether you’re using the proper key. If so, the PCM provides ground to the auto shutdown relay (ASD), also called the MAIN relay which then operates to provide power to the totally integrated power module (TIPM) which provides power to the fuel injectors and ignition coils.
The rest of the circuit is not being supplied with power. When the fuel pump and automatic shutdown relay are powered by the powertrain control module (PCM), terminal number 30 connects to terminal 87 in an on position. Voltage is being supplied to the remaining part of the circuit by terminal number 87.
Where is terminal 86 on a fuel pump relay?
The (PCM) grounds the coil side of the relay through terminal number 85. Terminal number 86 supplies voltage to the coil side of the relay. When the (PCM) de-energizes the (ASD) and fuel pump relays, terminal number 87A connects to terminal 30. This is the OFF position.
How to shut down a jeep ASD relay?
1 Lost 12 volt DC electric power. 2 Sees the spark weak or dead on the ignitor drive to Ignition coil primary pin. 3 Crank sensor bad. 4 Cam sensor bad, or misfiring, CMP. 5 ASD input read back pin fails. 6 Same ASD output read back. 7 Immobilizer active.
Where does the Powertrain Control Module grounds the ASD relay?
The Powertrain control module grounds the ASD relay from the side of the coil through terminal 85. Voltage is being supplied to the coil side of the ASD relay by terminal 86