When does the crankshaft position sensor need to be relearn?
The PCM needs to learn the variability of the Crankshaft Position Sensor to better detect misfire conditions. Whenever the PCM is replaced, the Crankshaft Position Sensor Relearn procedure needs to be completed. The Crankshaft Position Sensor Relearn procedure requires the use of a scan tool that has this feature equipped.
Where is the sensor on the crankshaft pulley?
Locate the sensor on the front of the motor near the crankshaft pulley and use the appropriately sized socket and ratchet handle to remove the sensor’s hold down bolt. Gently but firmly, twist and pull the sensor to remove it from the engine. Step 4: Prepare the o-ring.
Is the cam sensor the same as the crank sensor?
It expects the cam sensor to send signal pulses in time with the crankshaft sensor so the proper cylinders get spark and fuel at the correct time. Your cam sensor is in the distributor and changing it does not require a relearn as it is a different style sensor than the crank sensor.
What happens to the crank sensor on a GMC?
The crankshaft sensor on GMC vehicles is synced to the powertrain control module, or PCM. When the crank sensor is replaced, it must be resynced to the PCM. Without resyncing, the PCM cannot properly determine the position of the crankshaft.
Is the crankshaft position sensor reprogramed also?
A dealer is not the only place that can do a re-learn, pretty much any good shop with a bi-directional scan tool can handle it as it is a very common item to be done, even for some diagnostic work. helpful? Is it the same with the cam position sensor also?
The crankshaft sensor on GMC vehicles is synced to the powertrain control module, or PCM. When the crank sensor is replaced, it must be resynced to the PCM. Without resyncing, the PCM cannot properly determine the position of the crankshaft.
It expects the cam sensor to send signal pulses in time with the crankshaft sensor so the proper cylinders get spark and fuel at the correct time. Your cam sensor is in the distributor and changing it does not require a relearn as it is a different style sensor than the crank sensor.
Do You need A Scanner to crank relearn?
These Crank Relearn Instructions may not apply to all vehicles. But they’re close to how it’s done on most cars. Connect a scanner to make sure there are no trouble codes stored in the computer’s memory.