What happens if the ignition relay does not work?

What happens if the ignition relay does not work?

When the ignition relay fails, it can cause the ignition system to be activated constantly, even when you have removed the keys from the ignition. This means the circuit will not open after you remove the key, and the battery will drain.

Can a bad ignition switch cause a bad starter?

The first thing to check in these situations is the battery. If the battery is OK, then you have either a bad starter or a bad ignition switch. With a little bit of time and some patience, you can tell which one is the problem. What Else Is Working?

What happens when you turn off the ignition key?

When you switch off the ignition key, the ignition relay should also shut off power to all engine components; otherwise, it will drain the car battery when you let the car stands over the night. When the ignition relay fails, it can cause the ignition system to be activated constantly, even when you have removed the keys from the ignition.

What are the signs of a bad starter relay?

Broken or corroded wiring – Damaged or dirty wires to the battery or to the starter solenoid (or wires that are loose) can prevent sufficient power from reaching the starter. Alternator – The alternator is designed to power all of your car’s electrical systems when the vehicle is running. It also recharges the battery.

The first thing to check in these situations is the battery. If the battery is OK, then you have either a bad starter or a bad ignition switch. With a little bit of time and some patience, you can tell which one is the problem. What Else Is Working?

What does no start no crank no click mean?

If you have a late model GM vehicle and turn the key only to hear nothing, you’ll most likely think you have a dead battery—and you may. But a no start, no crank, no click condition can be far more involved than that. In the old days, power flowed through the ignition switch and down to the starter solenoid. Not anymore.

Why does my car not start when I jump the solenoid?

If your car won’t start and the problem is not caused by a dead battery, then you might need to jump the starter solenoid to get your car moving again. The starter solenoid is responsible for sending an electrical current to the starter motor.

What are the wires in a classic car starter relay?

Classic car starter relays will often have four wires in the connector. With the ignition key in the on position, there should be power on the heavy gauge red wire and a strong ground on the black wire.

What to do if your bike’s fuses have blown?

First off check your fuses. The main fuse has probably blown and maybe others. Is is it the fuses, you need to find out whats blowing them. bad earth, short etc. Check all connections and especially earth points. Water and moisture in couplings too. Check the battey next..Its NOT the battery that runs the bike or the lights etc, its the generator.

What to do if your bike ignition is not working?

If the engine isn’t running and the rest of the electrics are dead I’d first check the connector from the generator to the rest of the wiring and also the connector to the ignition switch, and then the ignition switch itself. As the other guy said, you may need a multimeter to do this properly.

What causes the ignition to shut off so fast?

Situations occur when there becomes corrosion inside of the ignition relay. This can cause the connection area inside the relay to become too small – which will cause the ignition to shut off and on super fast.

Why are the warning lights not working on my Triumph Stag?

If the warning lights are not working then it’s an electrical fault i.e. The ignition circuit. Start with checking the components, and wiring between the battery and the ignition switch. Check the ignition switch itself, and then the wiring from the ignition switch to the coil.

Are there any fuses in the ignition switch?

Assuming a conventional ignition switch system. Normally no fuses involved en-route to the ignition circuit itself but the Ignition switch (position 2) also usually supplies the items you mention (as not working) thro’ their individual FUSED circuits.

How old is the battery on a triumph?

From experience you won’t get much of a response from the bikes brain below 12.8v. How old is the bike / battery. This cold weather will kill an untended battery stone dead. First thing I do after a ride is connect to an intelligent trickle charger. Hi Gus. Think that 12v voltage sounds a bit low for starting a Triumph with EFI.

What should I do about my Triumph Stag battery problem?

Use an inline fuse, like 20A to protect the wiring. Switch on only a moment before starting and switch off once “arrived” to avoid draining the battery and cooking the coil. But make it a neat installation, as temporary wirings can cause failure like short-circuits and fire.

When the ignition relay fails, it can cause the ignition system to be activated constantly, even when you have removed the keys from the ignition. This means the circuit will not open after you remove the key, and the battery will drain.

Where is the ignition relay located in a car?

The ignition relay is often located in the fuse box under the hood. It can also be located in a fuse box under the dashboard inside of the car. The ignition relay’s exact location may differ from vehicle to vehicle depending on the design of the vehicle and the company that manufactured it.

How much does it cost to replace an ignition relay?

An ignition relay costs 5$ to 50$ and labor costs 10$ to 50$. You can expect a total of 15$ to 100$ for an ignition relay replacement. The ignition relay itself is often very cheap, and you can expect it to cost under 10$, depending on if you want to buy an OEM original one or aftermarket.

How can you tell if your starter relay is bad?

The most obvious warning sign that a problem with the starter relay exists is when the vehicle won’t start when you engage the ignition process. As stated above, electronic keys do not have a manual ignition switch. However, when powered, it should send a signal to the starter relay once the key is turned or the starter button is pressed.

Is the starter relay part of the ignition system?

One of the most important – and most forgotten – components of any vehicle’s ignition system is the starter relay. This electrical part is designed to redirect power from the battery to the starter solenoid, which then activates the starter to spin over the engine.

Can a bad ignition switch cause a car to not start?

If you do not have power to these pins, the ignition switch is bad and will need to be replaced. If you can narrow down the options that would explain why you can’t start the car, even if you don’t plan to make the repairs yourself, you will be better prepared to discuss it at the shop with a mechanic.

Can a bad ignition switch cause a starter relay to fail?

Although it’s unlikely that you’ll ever experience a problem with the starter relay, it is prone to mechanical failure and will need to be replaced by a professional mechanic if it wears out. Most of today’s modern cars and trucks have an electronic ignition switch that is activated by remote key.

How can I tell if my ignition relay has gone bad?

Here is a quick easy to follow testing and diagnostic procedure for finding out if the ignition relay has gone bad. To test for voltage drop, set your multimeter to 20V DC. Connect the black probe of the multimeter to the ignition switch circuit Connect the red probe with the red battery wire Ask someone to turn on the ignition

How does the ignition relay work on a car?

The ignition relay is basically an electrical device that works as a switch for the power to the ignition system and the fuel system of your vehicle. The ignition relay is activated as soon as your turn on the ignition of your vehicle with the key.

What should I do if my ignition switch is not working?

How To Fix It: After ensuring the rest of the electrical system is intact, such as fuses, relays, and circuits, replace the ignition switch. The transponder antenna surrounds the ignition cylinder. If it doesn’t recognize the transponder key, it doesn’t allow the engine to run. https://www.gettyimages.com/license/525320791