Is there a rubber stopper on a Nissan Xterra?
If you have a NISSAN (I have a 2001 Xterra) and your cruise is out, this is more than likely the culprit. I have a penny glued onto that also, which will stay that way until I need to mess with it, because I am not going to go through this again because I don’t like it under there…
How to turn off a check engine light on a Nissan?
Wait 10 seconds. Press the gas pedal completely down with your foot and hold it there for 10 seconds, or until the SES light blinks on and off. Step on the gas pedal and hold it down completely for another 10 seconds and then release it. Turn the ignition key to the off position. Wait 3 minutes for the ECU to automatically reset.
How long does it take to install a light bar on a Nissan Xterra?
Especially since the front of the Nissan Xterra has a little slot that is built almost perfectly for the lightbar. The whole process took about 2 hours. Most of it was figuring out how to mount the bar and wire everything up. Make sure that when you wire the light-bar, you keep the wires off of anything hot inside the engine bay. They will melt.
Why are my dash lights not working on my Nissan Patrol?
This may have something to do with the tacho feed coming from the alternator. I ran a 16mm cable from one of the threaded studs under the body around the handbrake/transmission cross member area to a bolt on the cross member. That should stop any earthing problems because the chassis normally isn’t earthed.
If you have a NISSAN (I have a 2001 Xterra) and your cruise is out, this is more than likely the culprit. I have a penny glued onto that also, which will stay that way until I need to mess with it, because I am not going to go through this again because I don’t like it under there…
Wait 10 seconds. Press the gas pedal completely down with your foot and hold it there for 10 seconds, or until the SES light blinks on and off. Step on the gas pedal and hold it down completely for another 10 seconds and then release it. Turn the ignition key to the off position. Wait 3 minutes for the ECU to automatically reset.
Can a Nissan plug be replaced with a push pin?
So I removed the push pin intending to replace it with the Nissan part, but it had no wear after three years of driving. I put it back in and did not use the Nissan plug I bought. Bottom line is the plastic push pin works fine and will last as long as the Nissan plug. It’s very easy to install and they’re cheap.