How do you test a stator on a ATV?
As with any electrical circuit, the stator in an ATV can be tested for continuity with a standard multimeter.
- Pull both of the stator’s pin-connector plugs from the wiring harness with your hands; the two plugs each have one male pin and multiple female sockets.
- Set a multimeter to the DC “ohm” or “1X” or setting.
Can a stator be replaced on a Polaris Sportsman?
In the past, this was a very costly repair. Replacing the whole stator requires partial engine disassembly. This is quite a task for the home mechanic, so, your ATV most likely ended up in a repair shop or at a dealership. If you are a mechanic, it’s still a chore to repair this stator problem.
What to do if your stator on your ATV is bad?
This is a free and easy fix so try it out if your battery is still good. Voltage regulator rectifier unit: If your voltage regulator is bad, you’ll have the same problems as if your stator is bad. This can make it difficult to determine, which is the problem. You can test this with a multimeter to see if it is working.
Why does my Polaris Sportsman 500 not start?
After testing all coils , valve lash , compression (115psi) and all tested ok I bought a used cdi . After cdi install it still wouldn’t start (no spark) !
How can I tell if my stator needs to be replaced?
This test makes sure that the stator isn’t shorting out to the ground. Your meter should read “OL” or open line. If the multimeter is picking up a reading, it means your stator needs to be replaced. Repeat this test for each of the windings.
What happens if your stator on your ATV is bad?
If your stator is bad, your battery will not charge while you’re driving the ATV. Unfortunately, this can be caused by a variety of other issues with your ATV. Stators tend to be reliable, so before you go replacing the stator, check on these other components: Your battery: Will the battery charge if you put it on a separate charger?
How to start an ATV that wont start?
1 Remove the spark plug from the cylinder-head and connect it to the spark-plug wire or ignition coil. 2 Grab the plug wire and hold the plug about 1/8th of an inch away from the cylinder head. 3 Activate the starter. 4 As the motor turns, you should see repetitive bright blue spark arching from the spark plug to the cylinder head.
How can I tell if my stator is bad?
The only way to know if it’s your stator is to test the stator itself. Luckily, testing is simple. Even those who aren’t mechanically inclined can test their stator by referring to their service manual and following the steps outlined above. So if you aren’t sure, do the test.
Why is my ATV not getting a spark?
You will find the proper steps for troubleshooting an ATV that is not getting a spark further down this post. If the spark plug is still dry after cranking the engine for a few seconds, you know that fuel, for some reason, is not getting to the cylinder.