What should I do if my Honda S2000 ABS light is not working?
You should use a diagnostic tool which covers the airbag system such as the iCarsoft MHM V1.0 Honda OBD Code Reader. The kits will tell you where within the airbag system the fault is occuring, and also allow you to clear the dashboard airbag light. Honda S2000 ABS Dash Light – indicates a problem within the ABS or Anti Lock Braking System.
Where is the ABS light on a Honda Accord?
Look behind your glove box for a blue connector with two wires going to it. The connector will be inside a holder. To retreive the DTC, remove the connector from the holder and insert a paper clip into both pins. Now turn your key to the until the ABS light comes on; start counting flashes.
What should I do if my abs light is on?
If yes, check the charging system. If no, then an intermittent failure – OK. If the Check Engine Light or the ABS lights are on, check these first. (You have the ABS light on so refer to above first.) Check ground or a short between PCM and ABS/TCS control unit. Check for loose connectors at the PCM. Check the PCM.
What does the ABS light mean on a Honda CRV?
The ABS light is different than the brake warning light itself. The brake light indicates that there is a problem with the physical braking system and that your CR-V is unsafe to drive. Yes, you can drive your CR-V with the ABS light on.
What to do if your Honda ABS light keeps coming on?
Turn the ignition switch off, remove the key and disconnect the jumper wire from the OBD connector. If the ABS light comes back on again after step #7, do the entire procedure again, it may take a few tries to get the fault codes to clear.
When does the Check Engine light come on in a Honda?
This article applies to the Honda Civic (1992-2000), and Accord (1990-2002). The check engine light in your Honda offers important diagnostic information, which will alert you of a serious problem like a bad catalytic converter. However, the check engine light also appears when the fuel tank cap is loose, or a change in humidity has occurred.
How can I get my Honda dash lights to stay on?
Turn the Ignition switch OFF and take the key out. Short pins 4 and 9 on the OBD connector located under the dash on the driver side. I used a paper clip, but any stiff (solid) light gauge wire will do.
How to reset ABS and TCS lights in Honda Odyssey?
Check ground or a short between PCM and ABS/TCS control unit. Check for loose connectors at the PCM. Check the PCM. Check for loose connectors at the ABS/TCS control unit. Check the ABS/TCS contol unit. I checked the fuse box under the hood and replaced the blown fuse #50 (30A) and reset the lights.