What is valet mode on my Jaguar?

What is valet mode on my Jaguar?

Hear this out loudPauseValet mode allows the vehicle to be driven and locked by a parking attendant, without giving access to the luggage compartment. Valet mode also prevents operation of the touchscreen, to prevent access to phone numbers or navigation addresses.

How does valet mode work on a Jaguar?

Only essential driver assist features are available, such as cameras and parking aid. Activate valet mode via the Master PIN. See GENERAL SETTINGS. Alternatively, use a temporary PIN, if the master PIN is unknown, to allow someone other than the owner to set valet mode. When set with the master PIN, only the master PIN can unlock valet mode.

How are the warning lights displayed on a Jaguar?

If a warning message is displayed along with a red warning light (highest priority), investigate the fault immediately. If more than one message is active, each is displayed in turn for two seconds in order of priority. Displayed when the brake fluid level is low. Depending on your location, warning light may be displayed in red letters BRAKE.

How do you cancel the valet pin on a Jaguar?

Enter the Master PIN or a memorable four digit temporary PIN. When a temporary PIN is used, it has to be entered a second time to confirm the PIN. To cancel the PIN, touch the return icon.

How to do a TPMS reset on a Jaguar?

No special tools are required to perform this relearn procedure. Inflate all tires to pressure listed on the placard. Drive the vehicle for at least 10 minutes while maintaining a speed of 30 MPH, or more. All sensor IDs will be memorized automatically.

When to pull off the road in a Jaguar?

Pull off the road when safe to do so and allow the engine to cool. When cool, top up with coolant if required. This will be displayed when the vehicle has possible loss of power or driveability. Displayed when the engine has defaulted to limp home mode. The air suspension system is too low.

Why is my TPMS not working on my Jaguar?

TPMS sesnsors are defective, an unapproved accessory is interfering with the TPMS or a general fault has been detected in the TPMS. The tyre is significantly under inflated. Stop the vehicle as soon as possible, check the tyres and inflate them to the recommended pressure or change wheel.

Why do I get a warning message on my Jaguar?

Displayed when the engine has defaulted to limp home mode. The air suspension system is too low. Start the engine and wait for the message to clear before driving the vehicle. If the message is displayed while you are driving, restrict your speed until the message is cleared. If the message is persistently shown, inform your Jaguar Dealer.

Why is my wash / wipe not working on my Jaguar?

If wash/wipe is selected when this message is displayed (even if it has been cleared from the message centre), the programmed wipe after washing will not operate. This is to avoid smearing the windscreen if the reservoir is empty. Top up the washer fluid at the earliest opportunity. The fuel filler cap may be loose.

Posted In Q&A