How do you start a Honda CBR 125?
Remove the coil, remove the plug, plug in the spark plug to the coil and hold the base (threaded part of the spark plug) against the engine (where there’s good ground) turn on the bike and push the starter button to check if the spark plug works.
How to troubleshoot a bike that wont start?
Once all 3 sensors are bypassed/tested, try to start the bike. Make sure you’re in neutral when you do this. If your bike starts, it’s all a matter of the process of elimination. Put each sensor back 1 at a time and try to start the bike after. When it fails, you know what your problem is. Replace. Okay, still wont start? Now what…
What makes a Honda CBR bike not start?
Your Bank Angle Sensor (BAS), Neutral Position Indicator and Kickstand sensor can all prevent your bike from starting.
Why does my bike make a clicking noise when I start it?
This post is to explain what the noise is and why it happens. The starter motor on a bike uses a lot of power to turn the engine. The starter button cannot handle the current that the starter draws from the battery so a large electric switch called a solenoid is used.
Why does my low voltage relay keep buzzing?
If your relay starts to buzz, it indicates a failure for one of two reasons: One, your low voltage relay may have failed in either the ON or OFF position and will need to be replaced. Or two, you have a bad switch connected to your relay that is stuck in the ON position. These momentary…
How to troubleshoot a Honda CBR that wont start?
If this doesn’t happen bypass your kill switch by disconnecting the white 7-pin connector on the right side of the bike near the frame (next to the red 2-pin connector). Using a piece of wire and two small alligator clips jump the pins for the White/Black & Black wires on the bike side of the connector (not the switch side).
Once all 3 sensors are bypassed/tested, try to start the bike. Make sure you’re in neutral when you do this. If your bike starts, it’s all a matter of the process of elimination. Put each sensor back 1 at a time and try to start the bike after. When it fails, you know what your problem is. Replace. Okay, still wont start? Now what…
This post is to explain what the noise is and why it happens. The starter motor on a bike uses a lot of power to turn the engine. The starter button cannot handle the current that the starter draws from the battery so a large electric switch called a solenoid is used.
What should the compression be on a Honda CBR?
The manual indicates 178psi for each cylinder. These test kits will usually indicate around 120psi. To test compression, thread the tester into the plug hole using the appropriate adapter, hold the throttle at WOT and attempt to start the bike.