Where is the fuse box on a GMC Acadia?
GMC Acadia (2007 – 2008) – fuse box diagram. Year of production: 2007, 2008. The instrument panel fuse block is located under the instrument panel on the passenger side of the vehicle.
Where are the airbags on a GMC?
Left-hand Front Seat Belt Pretensioner High And/Or Low Circuit Short To Ground or Earth OrVoltage (12 volt VSS) Left-hand Roof Panel Airbag Module High And/Or Low Circuit Short To Ground or Earth OrVoltage (12 volt VSS) Left-hand Roof Panel Airbag Module High And/Or Low Circuit Short To Ground or Earth Or Voltage (12 volt VSS)
How to reset GMC airbag module ( SDM )?
Questions? Call us at 888-779-9029 M-F 9-5 EST Passenger Airbag Module Deployment Circuit – (Single Stage Or Stage 1) Short To Ground or Earth Or Voltage (12 volt VSS) Out Of Range Passenger Airbag Module Deployment Circuit – (Single Stage Or Stage 1) Short To Ground orEarth Or Voltage (12 volt VSS) Out Of Range
When does the GM airbag light come on?
The airbag light, or SRS (supplemental restraint system) light, on the GM dashboard shines whenever there is a malfunction with the airbag deployment system. The vehicle needs inspected and fixed to ensure against accidental deployment of the airbag.
Where is the fuse box on a car?
The fuse box is located on the passenger side next to the battery. When your vehicle has properly warmed up then you want to turn your vehicle back off and unplug both fuses, cut power by disconnecting the battery .
How to change the blinker on a GMC Acadia?
2010 Saturn Outlook XE 3.6L V6 Change a rear blinker Don’t send mixed signals – if your turn signal doesn’t blink, or blinks rapidly, you likely have a burnt out bulb 2012 GMC Acadia SLE 3.6L V6 Checking the windshield washer fluid There’s no reason to check the washer fluid level without adding some – see how to do it here!
How do you repair an interior fuse box?
1. Getting Started – Prepare for the repair 2. Remove Cover – Locate interior fuse box and remove cover 3. Locate Bad Fuse – Find the fuse that is tied to the bad component 4. Remove Fuse – Take out the fuse in question and assess if blown 5. Test Component – Secure the cover and test component 6. More Info.