When did Mazda stop using timing belt in Miata?
From 1989 to 2005, all Mx-5 cars featured a timing belt. From 2006 onwards, all cars with the MZR and SkyActiv-G engines have a chain. The 1.6L Mazda B engine which the Miata debuted with featured a camshaft angle sensor and electronic fuel injection with lighter parts as well.
Is there rust on my Mazda MX 5 Miata?
If you’re thinking of buying a second-hand MX-5, here’s what you should be wary of. Rust is, by far and away, the MX-5’s biggest enemy. The most likely locations to suffer from rust are the rocker panels and the fender arches.
Is there a chain on a Mazda Miata?
From 2006 onwards, all cars with the MZR and SkyActiv-G engines have a chain. The 1.6L Mazda B engine which the Miata debuted with featured a camshaft angle sensor and electronic fuel injection with lighter parts as well.
When to remove water pump pulley on Miata?
Remove the water pump pulley. 1990 – 1991: Remove the accessory belt pulley from the crankshaft pulley. This is easier if you put the car in gear to keep the engine from turning. Loosen the bolts holding the pulley in place.
From 1989 to 2005, all Mx-5 cars featured a timing belt. From 2006 onwards, all cars with the MZR and SkyActiv-G engines have a chain. The 1.6L Mazda B engine which the Miata debuted with featured a camshaft angle sensor and electronic fuel injection with lighter parts as well.
Where does the belt go on a Miata?
The belt closest to the radiator goes from the engine to the air conditioner compressor then the power steering. Not all miatas have this belt depending on A/C on power steering. The tension in this belt comes from the air conditioner compressor pulley. The tensioner (circled) needs to be adjusted to remove the belt.
From 2006 onwards, all cars with the MZR and SkyActiv-G engines have a chain. The 1.6L Mazda B engine which the Miata debuted with featured a camshaft angle sensor and electronic fuel injection with lighter parts as well.
Remove the water pump pulley. 1990 – 1991: Remove the accessory belt pulley from the crankshaft pulley. This is easier if you put the car in gear to keep the engine from turning. Loosen the bolts holding the pulley in place.