How can I change the lower control arm?
The secret to changing the lower control arm on this is to loosen the main bolts on the sub frame. I typically just do the two on the passenger side. There are also to steel plates that if you remove the 14 mm bolts on those that will allow you to drop the bolt down at least an inch and a half to 2 inches before they come all the way out.
Where is the lower control arm ( passenger side )?
If you insist the engine/trans must be removed completely to access the LCA’s bolt that’s hidden under the right side mount, then I’ve spotted four motor mounts and will remove them. But, 2) Where is the rear mount you previously suggested I losen?
How much does it cost to replace control arm?
If you decide to have a professional replace your control arm, which is a smart move if you’re uncertain of your mechanical prowess, expect to pay anywhere from around $500 to well over $1,000. The job can be even more costly if you have a high-end luxury or performance car.
The secret to changing the lower control arm on this is to loosen the main bolts on the sub frame. I typically just do the two on the passenger side. There are also to steel plates that if you remove the 14 mm bolts on those that will allow you to drop the bolt down at least an inch and a half to 2 inches before they come all the way out.
How to replace lower suspension arm on Toyota?
This do-it-yourself article provides instructions for replacing either the driver- or passenger-side lower suspension control arm on Toyota and Lexus vehicles, including:
How to remove lower control arm and bushing?
Apply some penetrating oil to ease removal. The nut that secures the bolt contains a tab to prevent it from spinning when loosening or tightening torque is applied to the bolt. There is very little clearance to insert an open-end wrench to stop the bushing nut from spinning.
Where is the control arm located on a Toyota?
The other end of the control arm is attached to the steering knuckle via the lower ball joint. With most Toyota vehicles, the control arm is bolted to the ball joint, which makes it relatively easy to remove the control arm.