When do you need to replace the alternator belt?
Regardless of which design your vehicle uses, you will likely have to replace the belt that powers your alternator at some point in the lifetime of your vehicle. You can replace these belts yourself using common hand tools. Locate the alternator or serpentine belt.
Can you drive a car without an alternator belt?
You can drive your car without either of those belts. However, you won’t get very far without the belt that turns your alternator.
What happens when the serpentine belt fails on an alternator?
The serpentine belt powers the alternator, and if it fails, the alternator will stop working the moment your belt wears out and breaks, or the pulley becomes damaged. This can also happen if the serpentine belt is not tightened correctly. Most cars have automatic tensioners, but these can fail, so it is better to double-check.
What happens when the alternator doesn’t work?
Since your alternator is no longer providing any juice or current to run the required eletronics for a car, truck , etc to run, Time depends on how long it will take for your battery to go low so your car stalls or acts erratically and of course stops. That is assuming the serpentine belt also runs the alternator.
What’s the best way to loosen an alternator belt?
Use a breaker bar or socket wrench to loosen the auto-tensioner. Many newer model vehicles come equipped with an auto-tensioner pulley. The pulley presses upward as the belt wraps around it so the belt remains under constant, steady tension.
Can a serpentine belt be used for an alternator?
If your vehicle has an alternator belt instead of a serpentine belt, this is the method you will need to use. Be careful not to damage the wiring going into the alternator. The alternator provides the power the engine needs to run through those wires. Slide the belt off of the pulleys and remove it from the car.
How big of a drive do you need for an alternator?
It is possible that your vehicle uses a 3/8 inch drive or even a bolt on the tensioner pulley, so refer to your particular vehicle’s service manual to ensure you have the appropriate tools. Rotate the wrench clockwise to relieve the pressure it is placing on the belt.
Why does my alternator not get enough power?
I have narrowed it down to something not causing the alternator to get power because i have done the following: Autozone tested the alternator twice and both times reported good. They also tested the battery to be good (it’s only a few months old). Tested the continuity of the wire that runs from alternator to battery and that is good.
Regardless of which design your vehicle uses, you will likely have to replace the belt that powers your alternator at some point in the lifetime of your vehicle. You can replace these belts yourself using common hand tools. Locate the alternator or serpentine belt.
How do you check the tension on an alternator belt?
Check the belt tension. Once you have released the auto-tensioner or tightened the alternator bolts, check the tension of the belt to make sure it has seated properly on all pulleys. Pinch the belt between your thumb and index finger and try to wiggle it. There should be very little give to a properly installed alternator or serpentine belt.
Where does the serpentine belt go on an alternator?
If you do not have a diagram on the vehicle or in your service manual laying out the direction your serpentine belt travels through the pulleys, take a picture of it with your phone to refer to when installing the new belt. A strictly alternator belt will likely only go around an alternator pulley and the crank pulley at the bottom of the engine.