What to do if your Nissan Altima has no AC?

What to do if your Nissan Altima has no AC?

This is the automatic A/C system. Have a Nissan scan tool connected to the vehicle, and check the A/C module for faults. If you have no faults, try turning the A/C on, if it blows cold air, and the compressor engages, you need to wait.

Is there an issue with my Nissan Altima clutch?

(Playback ID: TyRd9Qs-MDlW_flE) An error occurred while retrieving sharing information. Please try again later.

Why does my Nissan Altima have a leak?

He mentioned it could be slowly leaking from the radiator as the sniffer seemed to detect something in that area but he was unable to see any leakage. A slow freon leak would cause the system to get less efficient over time.

Where is the refrigerant pressure sensor on a Nissan Altima?

The refrigerant pressure sensor is located on the high pressure side of the system. It detects whether the pressure is within range. It is located on the liquid tank (on top of it) next to the condenser. If the pressure is too low or too high, it would send the information to the A/C module]

Why is the clutch not working on my Altima?

Uh, there was NO obstruction there as the switch for low pressure does not work that way, which if done can easily blow your compressor into pieces. The switch simply cuts the power circuit to clutch off.

This is the automatic A/C system. Have a Nissan scan tool connected to the vehicle, and check the A/C module for faults. If you have no faults, try turning the A/C on, if it blows cold air, and the compressor engages, you need to wait.

What’s the air pressure in my Nissan Altima?

Pressures remains at 115 on high and low side. Back in car, turned of ac switch, 15 seconds turned on. Noticed high speed on radiator fan kicked on. Low pressure dropped and high pressure increased. 42/200. Cool air in cabin. Thought about it thru the night and decided maybe the relay was intermittently bad and I would change out.

He mentioned it could be slowly leaking from the radiator as the sniffer seemed to detect something in that area but he was unable to see any leakage. A slow freon leak would cause the system to get less efficient over time.

Why does my Nissan Altima not accelerate when the light turns green?

Sometimes when a red light and when the light turns green i put my foot on gas pedal and car would not move for few seconds and then finally it would go. Sometimes i have to pull to the side and turn off and the car and restart so it reboots because the car does not accelarate normally at all no matter how many times i try to accelerate.

Why does my Nissan Altima have delayed acceleration?

Every once and a while it has poor acceleration from stop and very occasionally it revs high rpm without shifting. I solve the high rpm issue by stopping, turning the car off and waiting 15 seconds before restarting. The delayed acceleration response might be the drive by wire system which is relatively new in these years of Nissan.

Why does my Nissan Altima go into limp in mode?

This theory is supported by the high rpm issue which might be the car going into “limp in mode” which is to allow the owner to drive the car to the nearest shop when accelerator issues occur. 26 people found this helpful. https://www.carcomplaints.com/news/2018/nissan-sentra-cvt-class-action-lawsuit.shtml

Why is my 2008 Nissan Altima not starting?

Car won’t start. Its a 2008 with 70,000 miles on it. I figure battery and we jump it and it starts. Off to Autozone to check battery. Battery bad. Replaced it. Still won’t start! Check new battery – fine. Check alternator – fine. Do some reading on here and it looks like the brake switch. Have my wife do a little test.

What’s the problem with my Nissan Altima brake switch?

At least she can get to the dealership without a tow which is 30 miles away. Update on brake switch issue. Brought into dealer this afternoon and they confirmed it was the brake switch. According to them its a common problem with the Altimas. $40 for switch and another $40 for installing.

What’s the name of the car that won’t start?

The last two mornings when I go outside to start the car (’08 Altima), the brake pedal is really hard to push and the car won’t start. It just cycles through ACC and ON. Eventually it will start. Took it into the dealership.

Why does my car not start when I press the brake?

The ikey uses the brake switch to tell if you’re pressing the brake when trying to start the car. So if your brake lights are still coming on then the switch is working and it’s probably the battery. If the brake lights aren’t coming on then its most likely the brake switch (cheap part that several have had to replace).

Is there a freon leak in my Nissan Altima?

IT would be ice cold at first, and the temperatures would increase with time, until the freon is very low, and then the compressor would disengage. In short, no, this is not a freon leak issue (even if you still have a leak). Thank you for your trust! Get back to me if you need more assistance…Thank you in advance for the positive rating…

Can a slow Freon leak cause an AC problem?

A slow freon leak would cause the system to get less efficient over time. IT would be ice cold at first, and the temperatures would increase with time, until the freon is very low, and then the compressor would disengage. In short, no, this is not a freon leak issue (even if you still have a leak). Thank you for your trust!

IT would be ice cold at first, and the temperatures would increase with time, until the freon is very low, and then the compressor would disengage. In short, no, this is not a freon leak issue (even if you still have a leak). Thank you for your trust! Get back to me if you need more assistance…Thank you in advance for the positive rating…

How to get Freon out of an air conditioner?

#2) You’ll need to Completly Discharge your Freon from your A/C System.Which should be Discharged in a Recovery Can.and not in the Air. #3) And after the System needs to be Completly Evacuated ,which takes a A/C Suction Pump.If your Doing this yourself I’m not Sure if you Can Rent this Pump or Not.

A slow freon leak would cause the system to get less efficient over time. IT would be ice cold at first, and the temperatures would increase with time, until the freon is very low, and then the compressor would disengage. In short, no, this is not a freon leak issue (even if you still have a leak). Thank you for your trust!

What kind of compressor does Nissan Altima have?

Your altima has a variable displacement compressor, the 4th gen is an on/off clutch. It is a common for the solenoid that controls displacement to fail stop working.

How can I Check my AC compressor clutch?

Use a digital voltmeter to measure the ground and voltage of the battery at the detached connector cable. Go on to check the fuse if you cannot read the voltage readings. Move on to the clutch relay if the fuse turns out fine.

What kind of clutch does a Nissan Altima use?

It is a COMPLETE A/C compressor clutch with Bearing pressed-in the pulley. The clutch includes all parts needed to replace your old clutch; (as shown in pictures) Hardware, electric connector, step by step DIY instructions; all included. Each unit is individually tested prior to packaging. These items are shipped from and sold by different sellers.

Your altima has a variable displacement compressor, the 4th gen is an on/off clutch. It is a common for the solenoid that controls displacement to fail stop working.

Can a Nissan Altima fit a 2.5 liter engine?

It will fit the Nissan Altima with 2.5 liter engine from 2002 to 2006 It is a COMPLETE A/C compressor clutch with Bearing pressed-in the pulley. The clutch includes all parts needed to replace your old clutch; (as shown in pictures) Hardware, electric connector, step by step DIY instructions; all included.

What should I do if my AC compressor clutch is not working?

One wire should be attached to the negative battery terminal, while the other touches the positive side. If your electromagnet is good, the compressor clutch will kick on. Remove the positive wire to release the clutch. You can repeat this process several times to ensure the clutch is working as it should.