How do you remove the back window of a quarter?
Quarter glass can be easily removed by one person without breaking when glass is held in place by weatherstripping. Work from the inside of your car, and work out the lip of the weatherstrip in the corner of the quarter glass gently.
Is it easy to remove rear window regulator?
Getting the rear window panel was easy. The inner panel (hard plastic holding the hydraulic piston/rod) was difficult to remove. I spent too much time getting this moved out of the way. The actual window regulator is much easier to remove if you can get to the bottom nut (#9) on the photo.
How do you replace the rear window regulator on An XK8?
Remove the rear quarter casing by freeing the two clips at the front edge (see Fig. 8) and pulling the casing forward along with the rear tang located in a positioning hole in the body. Position the casing toward the center of the car and out of the way (see Fig. 9).
How much does it cost to replace a Jaguar window regulator?
Jaguar apparently no longer sells just the regulator alone so the cost of a replacement unit with glass and seals can be expected to be significantly more. www.jagrepair.com D. Jensen 2 9/06 Fig. 1 New window regulator Disassembly
How to remove rear window regulator 996 cab-996 series?
Push rear power window -11- upward and push both locking tabs of the electrical connection -13- outward and disconnect. 1.Inserting power window. Connect electrical plug connection -13-, insert power window -11- into the window shaft from above and position in the mounts in the inner side section. 2. Screwing down convertible-top support.
Getting the rear window panel was easy. The inner panel (hard plastic holding the hydraulic piston/rod) was difficult to remove. I spent too much time getting this moved out of the way. The actual window regulator is much easier to remove if you can get to the bottom nut (#9) on the photo.
Is there a quarter glass in the rear door?
A quarter glass is never in the rear door. Quarter glass windows are either stationary or retractable, depending on the window next to which they are mounted.
Remove the rear quarter casing by freeing the two clips at the front edge (see Fig. 8) and pulling the casing forward along with the rear tang located in a positioning hole in the body. Position the casing toward the center of the car and out of the way (see Fig. 9).
Can a broken window regulator be replaced in a Carrera?
Having a broken window regulator can surely put a damper on that. The first step in replacing either the regulator or the power window motor is to remove the door panel (see Pelican Technical Article: Porsche 911 Carrera Door Panel Removal ).