What should I do if my Pontiac G6 is not turning over?
Most likely not, if your engine is not running, but still cranking then it should be alright. If you are trying to start it for a long time (30+ seconds) and it is still not turning over, then you might want to get it checked out.
How does the starter work on a Pontiac G6?
Once the start timer is activated, the PCM/ECM will continue to crank the starter until either the engine starts or a no start time limit is reached. Occasionally, the fuel pump module will take one or two seconds to build fuel pressure. Often this will occur after the vehicle sits overnight.
Why does my Pontiac G6 crank so long?
Most cars have a direct link between the ignition switch and the starter. Therefore if you hold the key it will crank as long as you hold the key. The G6 has a PCU controlled system. My car sometimes cranks longer than it should, and I agree it is annoying. Sometimes my remote start takes forever to get going.
What causes your car to shut off while driving?
When the ignition switch is frazzled, this will lead to a loss or power to your engine due to vibration such as hitting a round patch of street. The loss of power causes the engine of your car to die suddenly while you are driving on the road. Check out this video to see more details:
What does it mean when your G6 won’t start?
There are really two main ways that a vehicle will not start. The first and most common is when it won’t turn over. This just means that the engine doesn’t move when you turn the key. The second way that your G6 won’t start is when the engine turns when you engage the starter, but it won’t fire and run on its own.
Can a 2005 Pontiac G6 shift out of Park?
2005 Pontiac G6…Started vehicle after being locked for the day, would not allow to shift out of park, with brake depressed, or at all, unable to even depress the button on the shifter. Security padlock no longer blinks on the panel, lit solid yellow, maybe security engaged.
Why does my car shut off after I stop driving?
If you car shuts off after you stop it is because the engine is very sensetive at the idle. This can be caused by a lot of things but is usually caused by a lean fuel mixture, causing the idle to drop too low. A faulty throttle body can also cause this.
What kind of car does Pontiac G6 GT?
I have a 2005 Pontiac G6 GT model. Whenever I start my car it starts and then immediately shuts down. I don’t get a check engine light or anything. It will start if I give it a little gas and then it runs normally. I have also experience a loss in power and gas mileage even after replacing plugs and wires.
When did the Pontiac G6 come out in the US?
Pontiac G6. The Pontiac G6 is a midsize car that was produced by General Motors under the Pontiac brand. It was introduced in 2004 for the 2005 model year to replace the Grand Am. The car was built on the GM Epsilon platform which it shared with the Chevrolet Malibu and Saab 9-3 along with other General Motors vehicles.
How to program a replacement key fob for a 2007 Pontiac G6?
I was just curious if anybody here has experience in reprogramming a key fob for a 2007 Pontiac G6. The car seems to have a Vehicle Theft Protection system, because it engages when I lock up the car, but it doesn’t trigger when I mess with the door handle, not sure if thats important but I’m throwing it in there.
Why does my G6 not start when I turn the key?
This just means that the engine doesn’t move when you turn the key. The second way that your G6 won’t start is when the engine turns when you engage the starter, but it won’t fire and run on its own. When the engine isn’t turning over at all, that’s a bit easier to diagnose than when it is cranking but not firing.
How to program a new car key fob?
Refer to Electronic Diagnosis in Body and Chassis. Turn the ignition lock cylinder to the ACC position. Turn the ignition lock cylinder OFF, then back to ACC within 1 second. Open and then close any vehicle door. You will hear a chime when the remote control door lock receiver enters the programming/diagnostic mode.
What does mall stand for in Pontiac G6?
Pontiac called it MALL/PGM in the grand prix/sunfire/sunbird, etc… in the G6 apparently changed names… I found online a guy claims the MALL/PGM stands for “Multifunction Alarm Lock and Lighting” and PGM = “Programming”… that said in our cars, as you found no such label…
What is corporate bulletin number for Pontiac G6?
Please discard Corporate Bulletin Number 05-06-04-076A (Section 06 – Engine/Propulsion System). Some customers may comment on an intermittent extended crank time in hot engine restart and the starter motor may not disengage after engine start. Important: Before reprogramming the PCM, verify the customer concern.
Most likely not, if your engine is not running, but still cranking then it should be alright. If you are trying to start it for a long time (30+ seconds) and it is still not turning over, then you might want to get it checked out.
What to do if your car key won’t turn in?
Please do not poke around inside the ignition lock cylinder. A dirty ignition can be fixed by spraying small doses of an electrical cleaner in the ignition then gently sliding the key in and out of the ignition cylinder many times. ( DO NOT use this method on Honda, Acura, Toyota or any vehicle that uses a high security key ).
Most cars have a direct link between the ignition switch and the starter. Therefore if you hold the key it will crank as long as you hold the key. The G6 has a PCU controlled system. My car sometimes cranks longer than it should, and I agree it is annoying. Sometimes my remote start takes forever to get going.