What causes the air filter on a Yamaha to clog?
6) Air filter’s will clog when you fill it up with too much oil – it’s a common mistake Yamaha owner’s make by checking the oil cold – you need about 5 minutes hard run time before you can get an accurate reading or you’ll overfill and end up getting it in the filter.
What kind of parts does a Yamaha select use?
Select Make… Aprilia Arctic Cat BMW Buell Can-Am Ducati Genuine Harley-Davidson Honda Husaberg Husqvarna Indian Kawasaki KTM Piaggio Polaris Sea-Doo Suzuki Triumph Vespa Victory Yamaha Select Model… Isn’t it annoying when your bike unexpectedly breaks down.
Why does fuel selector stick on Yamaha Virago?
(Note: fuel selector valve does not apply to the 1000 and 1100) Fuel in the fuel lines does so as well. Some fuel may, at some time, have settled in the breather check valve, evaporated and caused the ball in the check valve to stick.
Which is the most reliable bike of Yamaha?
Some of those older model Viragos are the most reliable bikes ever built by Yamaha and will provide you with many years of service and possibly several hundred thousand miles of riding enjoyment.
Why does my Yamaha vx110 have no spark?
I finally got the engine installed in my 2006 VX110. It will not start, I see no spark. Tried some starting fluid, no fire at all. Turns over great, has new plugs, all 4 coils ohm out good – 1.2 ohms. Verified that the fuel pump relay works, verified that the slant detection relay is working correctly. All fuses appear good.
Is the fuel pump relay on my Yamaha vx110 working?
Turns over great, has new plugs, all 4 coils ohm out good – 1.2 ohms. Verified that the fuel pump relay works, verified that the slant detection relay is working correctly. All fuses appear good. Not sure what else I can test myself, any ideas. Front cover flywheel pickup coils plugged in? Thanks, David3aces.
How many ohms does a Yamaha vx110 have?
The vx only has one pulser coil, it ohms at 491 ohms, which should be OK, I think. At least that is what I have seen on other pulser coils (2 stroke). I also tested the 3 charging feeds from the lighting coil, all measure the same between each other, around 3 or 4 ohms.