How do you bypass the safety switch on a zero turn mower?

How do you bypass the safety switch on a zero turn mower?

How to Bypass Seat Safety Switch on Lawn Mower?

1. Step 1: Set the Mower on Flat Ground.
2. Step 2: Disconnect the Battery Terminal.
3. Step 3: Get Access to the Seat Safety Switch.
4. Step 4: Take off the Safety Switch Wires.
5. Step 5: Cut the Wire & Tape Them.
6. Step 6: Take the Seat Back to Its Position.

How to bypass the Husqvarna seat safety switch?

1 Move the seat all the way forward 2 Lift Seat 3 Unplug safety switch 4 Locate the shorting bar tabs on the plug (see picture) – both the 3 & 4 pin models SHOULD be the same: 5 Gently pull the shorting bar out of the plug: 6 Leave it UNPLUGGED to bypass the safety — PLUG IT IN to turn on the safety (so your dumb cousin can use it)

How can I bypass the safety switch on my lawn mower?

You can’t do so because of the annoying safety switch under the seat. To bypass it, you’ve to simply cut the switch off. You can do it with cutting pliers which is useful. After cutting this switch, you’ll notice that there are three wires. You should tape the wires individually with electric tape.

Is there a way to bypass a seat switch?

You aren’t the only person that hates safety switches. Most seat switches just unplug them to bypass them. This worked on my Craftsman LT2500. Thanks so much for the guide with pictures.

How to turn off parking brake on husvarna?

I just went to the shop and unplugged the switch and recieved the same results, i then bypassed it ( with a wire) same results…..i also cut the wires and twisted them together..( just in case …still the same results..

1 Move the seat all the way forward 2 Lift Seat 3 Unplug safety switch 4 Locate the shorting bar tabs on the plug (see picture) – both the 3 & 4 pin models SHOULD be the same: 5 Gently pull the shorting bar out of the plug: 6 Leave it UNPLUGGED to bypass the safety — PLUG IT IN to turn on the safety (so your dumb cousin can use it)

You can’t do so because of the annoying safety switch under the seat. To bypass it, you’ve to simply cut the switch off. You can do it with cutting pliers which is useful. After cutting this switch, you’ll notice that there are three wires. You should tape the wires individually with electric tape.

You aren’t the only person that hates safety switches. Most seat switches just unplug them to bypass them. This worked on my Craftsman LT2500. Thanks so much for the guide with pictures.