Are 1157 and 7528 bulbs the same?
The base of an 1157 and a 7528 is exactly the same. They both use a dual contact bayonet base (BA15D). Physically and electrically the bases for the 1157 and 7528 bulbs are completely identical. The difference is that an 1157 bulb draws 27 watts for the high filament and 8.3 watts for the low filament.
How to replace a turn signal switch on a car?
1 Remove the turn signal switch. The turn signal switch may be held on by a few screws or a pinch bolt around the column. 2 Disconnect the harness. Sometimes the harness connector will be located within the steering wheel trim. 3 Install the new switch. Fit the switch back into the column and reinstall the screws. …
Where is the turn signal relay on a Honda Accord?
Buy a replacement relay from an auto-parts retailer. Locate the fuse panel just beneath the dashboard on the driver side of the car. Remove the screw securing the fuse panel cover and remove the cover. Reach to the top-right corner of the fuse panel to locate the turn signal relay. The turn signal relay is a square-shaped relay.
How do you change the headlight housing on a Honda Civic?
Install the new headlight housing in reverse order to the steps above. Plug in the two wire harnesses into the new headlight housing, and place the housing into its proper location. Screw in the two 10mm bolts on top of the housing, followed by the two 10mm on its side.
What happens when you flip ignition on Honda Civic?
The battery is charged as well as properly connected, the spark plugs are firing, and the fuel line is intact. However, your car still won’t start, and the engine continues to sputter when you flip the ignition.
Can a Honda Civic turn signal switch be replaced?
This is not a difficult repair to do yourself, but it would be much easier to have it replaced by an automotive mechanic. Figure 3. 1996 to 2000 Honda Civic turn signal switch. According to the Honda-Tech community, combination switches can also be cleaned to work properly without having to replace them.
Why are my turn signal lights not working?
This project will take you 15 to 25 minutes to complete. If your turn signal lights are not working, it’s best to first check the most likely reason, which is burnt light bulbs. Gain access to the headlight housing through the trunk. Then, unplug each light bulb’s wire harness, and replace both bulbs with new ones.
How to replace the TPS sensor on a Honda Civic?
Honda Civic: How to Replace and Calibrate TPS. 1 Step 1 – Remove the TPS. To remove the old TPS, first disconnect the throttle position sensor wiring harness. Remove the two 12mm bolts and nuts to 2 Step 2 – Install new TPS. 3 Step 3 – Calibrate the new TPS. 4 Featured Video: How to Calibrate TPS Sensor.
Can a bad throttle sensor be replaced on a Honda Civic?
Honda has not made it easy to replace only a bad throttle position sensor, instead choosing to fasten it down with semi-permanent screws in many older models. While many people will simply replace the entire throttle body, this is obviously not necessary.