Can a power steering belt be removed from an engine?
Do not totally remove the power steering pump from the engine. Carefully remove the belt from the pulley making sure not to cut the belt. If it becomes too difficult to remove the belt, you might need to remove another pulley in the belt system.
How do you remove a belt from an auto tensioner?
Hold the tension from the belt, and slip the belt off the auto tensioner pulley to remove the belt and pulley system. Slowly release the tension to avoid damage or injury, and then remove the tool from the belt auto tensioner.
How to check the tension on a power steering belt?
To check the tension, lay a straight-edge along the outer edge of the belt. If the belt goes round more than two pulleys, use the longest run of the belt. Use your thumbs to push the belt inwards at its mid point, pushing quite hard.
Where is the power steering drive belt located?
The belt that drives a power-steering hydraulic-fluid pump is usually at the front of the engine , turned by a pulley on the crankshaft . It is generally separate from the belt that drives the water pump and alternator , but it may drive other components as well as the power-steering pump .
How do you tighten a power steering belt?
Step 12: Tighten the tensioner pulley and tighten the bolts. Using the same method as above, apply pressure to the tensioner pulley until the belt is tight on all three access points. Maintain pressure on the tensioner pulley and tighten the bottom then top bolts to tighten the power steering belt correctly.
The belt that drives a power-steering hydraulic-fluid pump is usually at the front of the engine , turned by a pulley on the crankshaft . It is generally separate from the belt that drives the water pump and alternator , but it may drive other components as well as the power-steering pump .
What to do if your power steering belt is too slack?
If the belt was too slack, increase the tension by levering the pump outwards with a strong screwdriver or flat bar. Lever against the cast front end of the pump body, just behind the drive-belt pulley — not against any other part of the body or pipework, which are easily damaged.
How do you test a power steering belt?
Grab the belt with your hands and spin the belt forward to test its operation. The belt should spin freely on the crankshaft, tensioner, and power steering pump pulley without trouble.
Do not totally remove the power steering pump from the engine. Carefully remove the belt from the pulley making sure not to cut the belt. If it becomes too difficult to remove the belt, you might need to remove another pulley in the belt system.
To check the tension, lay a straight-edge along the outer edge of the belt. If the belt goes round more than two pulleys, use the longest run of the belt. Use your thumbs to push the belt inwards at its mid point, pushing quite hard.