What is a fillet in engineering?
In mechanical engineering, a fillet /ˈfɪlɪt/ is a rounding of an interior or exterior corner of a part design. An interior or exterior corner, with an angle or type of bevel, is called a “chamfer”. Fillets commonly appear on welded, soldered, or brazed joints.
What is fillet in architecture?
fillet, (from Latin filum, “thread”), in architecture, the characteristically rectangular or square ribbonlike bands that separate moldings and ornaments. Fillets are common in classical architecture (in which they also may be found between the flutings of columns) and in Gothic architecture. See also molding.
What is a fillet used for?
In mechanical engineering a fillet is a rounding of the interior or exterior corner of a part. On the inlet fillets are concave while on exterior corners these are convex. Fillets are mainly used to reduce stress concentration compared to chamfers. These can easily distribut stress more uniformly.
What is chamfer and fillet?
A chamfer is a sloped or angled corner or edge, and a fillet is a rounded corner or edge. These edges can be located on either the interior or the exterior of a part.
What is fillet in CAD?
A fillet or round connects two objects with a tangent arc in 2D, or creates a rounded transition between the adjacent faces of a 3D solid. An inside corner is called a fillet and an outside corner is called a round; you can create both using the FILLET command.
Where is the fillet?
The fillet is a very tender steak muscle which comes from the lower middle of the back and forms part of the sirloin. The fillet muscle is so tender because it does the least work. It is also a very lean cut with little fat running through it, which means it doesn’t have quite so much flavour as other steak cuts.
What is fillet radius?
The fillet radius is the radius of the arc that connects filleted objects. Changing the fillet radius affects subsequent fillets. If you set the fillet radius to 0, filleted objects are trimmed or extended until they intersect, but no arc is created.
What is fillet in Autocad?
The fillet command is used to create rounded edges between the adjacent lines and faces in 2D and 3D. It is also used to connect two tangent arcs in 2D. Specify the radius of the Fillet and press Enter.
What is a fillet radius definition?
Fillet—A fillet which can be added both at concave and convex corners. The fillet radius is defined by either the Concave Radius or the Convex Radius values, depending on the type of the corner. This change in radius is clearly visible at the corners on the tool path.