How do I reset my Cisco Aironet 1200?

How do I reset my Cisco Aironet 1200?

Factory Reset via MODE Button Hold the MODE button until the Status LED turns amber (approximately 1 to 2 seconds), and release the button.

How do I reset my Cisco access point password?

Steps to Recover Password on a Cisco 1242 Access Point?

1. Connect to the 1242’s Web interface by directing a Web browser to the access point’s IP address as decided during its setup.
2. Pull out the power cord from the 1242.
3. Locate the “Mode” button on the access point.

How do I reset my Cisco Aironet 1140?

Use the System Configuration Setup page to restart the access point.

1. Click “Warm” Restart System Now to perform a warm restart of the access point. A warm restart reboots the access point.
2. Click “Cold” Restart System Now to perform a cold restart of the access point.

How do I reset my Cisco Aironet 1100?

1 Answer

1. Step 1 Disconnect power from access point.
2. Step 2 Press and hold MODE button while you reconnect power to the access point.
3. Step 3 Hold the MODE button until the status LED turns amber, and release the button.

What is default password for Cisco access point?

After the access point rejoins a controller, it adopts the default Cisco/Cisco username and password.

What should I do if I forgot my PLDT password?

What can I do if I forget the login username/password of my DSL modem/router?

1. Step 1 Turn off the router.
2. Step 2 Press and hold the reset button on the rear panel with a pin, then turn on the router.
3. Step 3 Release the reset button and wait for the device to reboot.
4. Note:

How do I recover my Cisco 9200l password?

Reconnect the power cord to the switch or the active switch. As soon as the System LED blinks, press and release the Mode button 2-3 times. The switch enters the ROMMON mode. Proceed to the Procedure with Password Recovery Enabled section, and follow the steps. After recovering the password, reload the switch or the active switch.

How do I Reset my Password on my Cisco switch?

As soon as the System LED blinks, press and release the Mode button 2-3 times. The switch enters the ROMMON mode. Proceed to the Procedure with Password Recovery Enabled section, and follow the steps. After recovering the password, reload the switch or the active switch.

What’s the password for my Linksys E1200 router?

Linksys E1200 has a login password set by default. On all models, the default password is admin. It’s case-sensitive, meaning that it won’t work with uppercase letters. You’ll probably want to change this password, though. But what happens if you do that and then forget it?

Can you reset the password on a Linksys router?

You can reset the password on your own. It’s actually as simple as setting the router to the default settings. In other words, you need to factory-reset the E1200 device. Here’s how to reset your Linksys E1200 router. First, plug the router in and power it on. Once it’s up and running, flip the device to access the bottom.