Why does my forklift Crank over but not start?
If you have 12 volts at the supply side of switch but not the switched side you most likely have a bad switch. There is the possibility that you do not have vacuum or oil pressure. Vacuum can be checked with a vacuum gauge and oil pressure with an oil pressure gauge. Both of these tools are readily available.
Why does my car not start when I crank the engine?
If the engine doesn’t crank, or makes an unusual noise when cranking, you may have a starting system problem. The car’s security system may have made an error that disabled the fuel or ignition system, or the chip in the key may have failed.
Why does my John Deere skid steer start hard?
At first it only started hard after running it for a long time and shutting it off and then trying to start it again after about a half hour or so, but it would only crank for about 8 seconds then and start so they had a hard time trying to diagnose it.
Where is the crank sensor on a John Deere skid steer?
The Crank sensor is mounted on the RH side of the block and reads off a tone wheel that is pressed onto the crankshaft.
Can a faulty fuel pressure regulator cause a car to not start?
In the event your Ford cranks easily, but doesn’t start within the first five or six revolutions of the starter motor, you may have a faulty fuel pressure regulator. If the regulator has failed completely, the vehicle will crank, but not start at all.
Why does my cobalt crank but wont start?
Cranking over motor with scan tool connected. Can see RPM. if I floor the throttle like it is in flood mode, The motor will try to start, Can hear it firing. a friend at work said it could be trimming fuel back, with scan tool it was trimed out at like -29 he said max was to be like -15 does this make sense? there is 2 different o2 codes.