How easy is it to change a driveshaft?
Changing your driveshafts is actually a simple task that a home mechanic can undertake without too much trepidation. It’s just a case of being thorough, being safe, and of course, having your trusty Haynes Manual to hand.
How much does it cost to change a drive shaft to rear wheel drive?
Drive Shaft Replacement Cost You can expect the parts cost to be anywhere from $320 to $750, while the labor costs are only around $150 to $190. If you have a rear wheel or four wheel drive vehicle which has a long drive shaft to power the rear wheels, then expect to pay somewhere in the range of $600 to $2,000.
Can you remove drive shaft?
A driveshaft must be removed to take out the transmission A driveshaft can be one or two pieces with a center support bearing in the middle. There are universal joints at either end of the driveshaft which act as flex joints that allow the differential to move upward when the car contacts a bump.
How much does it cost to change a driveshaft?
You can usually expect to pay between $320 and $750 for the average cost of the parts, while the cost of the labor is between $150 and $190. If you have a rear wheel or four wheel drive car, then the price of the broken drive shaft repair cost will be much higher.
What’s the best way to remove a driveshaft?
Hit the nut with the handle of a hammer to loosen the outer driveshaft. Undo and remove the driveshaft nut. Push the outer driveshaft towards the inner driveshaft, so that the outer one slides into the inner one. Pivot the driveshaft head outwards, you can now remove the driveshaft.
How do you replace an inner and outer driveshaft?
Undo and remove the driveshaft nut. Push the outer driveshaft towards the inner driveshaft, so that the outer one slides into the inner one. Pivot the driveshaft head outwards, you can now remove the driveshaft. To replace the inner and outer driveshafts you will need … a central gaiter and its fixings. You may want to change the cotter pin.
How do you remove a front drive drive bearing?
Step 1: Remove the front driveshaft. The front driveshaft is attached to the transmission output shaft and connected by four bolts. On some rear wheel drive vehicles, the bearing block bolts thread into nuts that are solidly mounted or welded onto the frame.
Where can I get a new drive shaft?
Driveshafts/Driveshafts, Rear Ends, Overdrive Units, Manual Transmissions and Transfer Cases, Full Service Shop. located in the Sparks/Reno area of Nevada. Select vehicle from table below to see Driveshafts/driveshafts we offer! Want to replace an aluminum driveshaft? Want to replace a carbon fiber drive shaft? Or just need a replacement?