How to remove ignition lock cylinder in Toyota Tundra?
This procedure was performed on a 2011 base Tundra. There are many more photos, should you desire. Turn the steering wheel to expose and remove Philips screws on either side to allow removal of lower steering column cover.. Remove the lower steering column cover.
How many spark plug failures has Toyota Tundra had?
I have a 2008 5.7 Tundra with about 25,000 miles on it near Houston, Texas. I am retired and drive it sparingly. It has had about four coil and spark plug failures.
How do you remove the ignition lock cylinder?
Insert bent wire into hole in ignition lock cylinder housing to depress the pin that retains the lock cylinder. Pull cylinder from cylinder housing using key in accessory position while that pin continues to be depressed by the bent wire. Installation is reverse of the above.
Can you change the ignition key on a Toyota truck?
Background: Recently bought a truck that had an ignition switch lock replaced in the past and the ignition key did not match other locks on the truck. I only had the single ignition key and had a mechanical key to fit the door.
How do you remove ignition switch from car?
Insert a straightened out paperclip into the slot just to the left of the key cylinder. This will lock the cylinder from starting. Inserting your screwdriver into the cylinder and turn it as far as you can to the right. Pull on both the paperclip and the screwdriver to gently slide the switch out of its current position.
What is the purpose of a Dorman ignition lock cylinder?
Dorman Ignition Lock Cylinders are part of the Ignition Lock Assembly. The purpose of the Ignition Lock Cylinder is to provide a level of security that requires a coded metal Ignition Key in order for the vehicle Ignition Switch to be operated and energized, thereby allowing the vehicle to be started and operated.