Do you need to replace bearings every time you repack them?
Once you’ve removed the inner bearing and grease seal, you can place the inner bearing with the outer bearing and castle nut in a clean container. You can discard the old grease seal. It should be replaced every time you remove it to repack the bearings. You can find replacement seals on Amazon or at your local auto or trailer parts store.
How to clean and repack wheel bearings and lug nuts?
Step 3: Remove the wheel from the hub. After the vehicle is raised, start on one side and complete the side before moving onto the other. The first step here is to remove the wheel from the hub. Use an impact wrench and socket or a star wrench to remove the lug nuts from the wheel.
Where to put wheel chocks when changing wheel bearings?
For example, you would place wheel chocks behind the rear tires if you are fixing a front wheel bearing and behind the front tires if you are working on a rear wheel. Loosen the lug nuts and lift the wheel using a jack. For proper access to the internal components of the wheel whose bearings you’re replacing, you’ll need to elevate the wheel.
How do you change wheel bearings on a car?
To change wheel bearings, start by lifting the wheel up on a jack, unscrewing the lug nuts, and taking the wheel off. Then, remove the brake caliper, the dust cover over the rotor, and the cotter pin and castle nut behind the dust cover. Next, pull the rotor off, remove the old hub, and take apart the hub assembly to access the wheel bearings.
How to replace front wheel bearing on Nissan Murano?
The only special tools needed to do the replacement quickly is a slide hammer with the FWD hub puller attachment; tools that can be easily rented. Otherwise, the hub assembly could be jarred free from the knuckle with hammer impacts; something I personally do not prefer to do but have know others to have done.
When to repack wheel bearings on a boat?
For boat trailers, repack the wheel bearings at the start and end of the boating season. Use marine wheel bearing grease. Repacking wheel bearings is cheap (less than $15) and you can do it yourself in a few hours. Pick up new grease seals, cotter pins and the wheel bearing grease at any trailer supply shop.
How to change brake pads and rotors in Nissan Murano?
If playback doesn’t begin shortly, try restarting your device. An error occurred. Please try again later. (Playback ID: -2dN1LeKobeagPsy) Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer. An error occurred while retrieving sharing information.
Where is the hub on a Nissan Murano?
The hub and bearing assembly are bolted on to the steering knuckle whereas most front wheel drive vehicles have their bearings and hubs press fitted in. The only special tools needed to do the replacement quickly is a slide hammer with the FWD hub puller attachment; tools that can be easily rented.