What is gain on boost controller?
GAIN is defined in the manual as the value to adjust the “boost consistency”. You don’t really need to know exactly what that means. You should set GAIN to 0 when beginning, and you will then test the car under WOT while paying attention to the boost pressure.
How do you set boost on Profec?
Start by setting your “start gain” at about 120(12psi). Then adjust your gain to about 20%. The SET should be at 0%. Work in increments of 2% and start to turn up the boost until you happy.
Do you need a tune for boost control solenoid?
When installing a 3 port EBCS, you will need a custom tune. Because the 3 Port EBCS operates so much more efficiently, without tuning, your car could over boost running factory targets.
Which is the best turbo for a Z31 300ZX?
88-89: Single Garrett T25 turbocharger with a factory boost setting of 4-5PSI and an engine compression ratio of 8.3:1 The T25 is pretty much worthless from a performance standpoint. The only advantage it offers is lightning fast boost response.
Is there an intercooler on the Z31 300ZX?
There is no stock intercooler at all. There is no compressor bypass valve or blow-off valve of any kind. The turbocharger uses an internal (integral) wastegate assembly to control boost, along with an external pop-off valve (not the same as a bypass valve), which on the front passenger side of the upper intake plenum.
Where is the air charge pipe on a Z31 300ZX?
The turbocharger uses an internal (integral) wastegate assembly to control boost, along with an external pop-off valve (not the same as a bypass valve), which on the front passenger side of the upper intake plenum. The air charge pipe (1) runs directly from the turbocharger to the throttle body; a little over a foot of total length.
When did the 300ZX Turbo come out in Japan?
A stock 300ZX Turbo, when it was released in Japan in 1983, became the car with the highest HP available in a Japanese standard production car.
What kind of boost controller does GReddy use?
GReddy Profec Boost Controllers The PRofec is compact, powerful and easy to use electronic boost contorller for standard pneumatic actuator or external wastegates. The large OLED Display, with the simple two-button / rotary-dial control, make for intuitive operation.
Where is the boost unit on a GReddy Profec?
By separating the display and control unit in the driver’s compartment, from the engine compartment-mounted, waterproof, sensor unit, it makes installation straightforward. Only one thin harness is required to be routed through the firewall.
What are the latest products from GReddy Performance?
Greddy Performance Products RS-RACE – Now Available! Boost Brigade by GReddy 2015 Fall Collection – original Tees, Snap-backs, Hoodies, Jackets, accessories and more…
What kind of circuit kit does GReddy use?
Circuit Spec SST Cooler Kit – Mit. Evolution X (CZ4A) Circuit Spec Oil Cooler Kit – Mit. Evolution X (CZ4A) Aluminum Suction Kit – Mit. Evolution X (CZ4A) ShopGreddy Exclusives – GReddy Nobori Flags, Socks, Masks, Decals and Air Fresheners… New Greddy banners to dress up your garage or home…