When did p0013 come up on my car?
I had P0013 (Exhaust Camshaft Position Actuator Solenoid Control Circuit) come up after finishing a 5 hour drive about a year ago. Basically I cleared the code, drove back to Toronto with no problems. Code hasnt come back and I’ve put about 10,000km more on it.
What’s the p0023 code on my Malibu?
I got a p0023/p0014 code on my 09 malibu. Changed the exhaust solenoid and reset light. Went to store and light came back on!!! What’s my next to do to fix this!!! Are your connectors in good shape to your Solenoids? Also, are you low on oil? What viscocity do you use? Has it been changed recently?
How to fix engine code p0010 on 2.4L?
Just remove the hold-down bolts & pull up on the actuators. Put engine oil on the new o-rings & don’t over-torque the hold-down bolts (torque spec is only 7 ft-lbs). The actuators are keyed differently (& have different part numbers) so you can’t interchange them.
What does trouble code p0011 mean on an ECM?
The camshaft (s) is (are) adjusted by the ECM through the use of an oil control valve (s) (OCV) also called variable valve timing control solenoid valves. When trouble code P0011 is set, it means that the intake camshaft in Bank 1 is more advanced than the ECM has told it to be. What Are The Symptoms Of Code P0011? What Is The Cause Of Code P0011?
I had P0013 (Exhaust Camshaft Position Actuator Solenoid Control Circuit) come up after finishing a 5 hour drive about a year ago. Basically I cleared the code, drove back to Toronto with no problems. Code hasnt come back and I’ve put about 10,000km more on it.
What should I do if I find a p0011 set?
If the initial P0011 sets and other codes are present then erase all codes and do five camshaft drive cycles and then re-investigate which codes come back. If any of these codes are present disregard and erase. If they come back it is electrical wiring or connection failure.
What are the possible causes of a p0011 Chevy?
P0011 CHEVROLET Possible Causes 1 Low or Dirty Engine Oil 2 Faulty Intake Camshaft Position Actuator Solenoid 3 Intake Camshaft Position Actuator Solenoid harness is open or shorted 4 Intake Camshaft Position Actuator Solenoid circuit poor electrical connection 5 Faulty Engine Control Module (ECM) More
Where do I find the trouble code on my Pontiac?
These are listed in numerical order for easy searching. When retrieving Pontiac trouble codes with an OBD II scan tool, proceed as follows: 1. Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. 2. Turn the ignition on. 3.
What is Pontiac check engine light code p1115?
P1114Engine Coolant Temperature (ECT) Sensor Circuit Intermittent Low Voltage – Read Our Article on Automotive Circuit TestingFor Help With This Pontiac Trouble Code P1115Engine Coolant Temperature (ECT) Sensor Circuit Intermittent High Voltage – Read Our Article on Automotive Circuit TestingFor Help With This Pontiac Check Engine Light Code
What does Bank 1 mean in DTC p0013?
If the PCM detects an open, a short to ground, or a short to voltage, DTC P0013 sets. The “B” camshaft refers to the exhaust, right, or rear camshaft (looking at the engine from the drivers seat). Bank 1 refers to the side of the engine that contains cylinder #1.
If the PCM detects an open, a short to ground, or a short to voltage, DTC P0013 sets. The “B” camshaft refers to the exhaust, right, or rear camshaft (looking at the engine from the drivers seat). Bank 1 refers to the side of the engine that contains cylinder #1.
I got a p0023/p0014 code on my 09 malibu. Changed the exhaust solenoid and reset light. Went to store and light came back on!!! What’s my next to do to fix this!!! Are your connectors in good shape to your Solenoids? Also, are you low on oil? What viscocity do you use? Has it been changed recently?
Just remove the hold-down bolts & pull up on the actuators. Put engine oil on the new o-rings & don’t over-torque the hold-down bolts (torque spec is only 7 ft-lbs). The actuators are keyed differently (& have different part numbers) so you can’t interchange them.
Where can I get the p0010 code on my car?
Went to AutoZone and got the P0010 code – Intake Camshaft Position (CMP) Actuator Solenoid Control Circuit. I haven’t had any major problems with this car.. yet.
Is there a p0011 code on my engine?
After diagnostics P0011 code was there. Engine Oil level is fine and i used to do engine oil replacement on regular basis .
What causes a p0013 code on an equinox?
A P0013 trouble code can cause the P0014 code to appear, so direct your attention to the P0013 code first. Remove the exhaust solenoids and check for sludge or metal particles. If you see sludge, you’ve got problems.
What does trouble code p0011 mean on a car?
The camshaft (s) is (are) adjusted by the ECM through the use of an oil control valve (s) (OCV) also called variable valve timing control solenoid valves. When trouble code P0011 is set, it means that the intake camshaft in Bank 1 is more advanced than the ECM has told it to be.
Why do I have DTC p0013 on my computer?
However, since you have the DTC P0013, it is pretty obvious that the problem is being caused by a circuit malfunction in the control solenoid circuit. It could be as simple as a loose connection at the solenoid electrical connector.
The camshaft (s) is (are) adjusted by the ECM through the use of an oil control valve (s) (OCV) also called variable valve timing control solenoid valves. When trouble code P0011 is set, it means that the intake camshaft in Bank 1 is more advanced than the ECM has told it to be.
When did the Saturn Vue Red Line come out?
Saturn introduced a special high-performance line of vehicles in 2004 under the name, “Red Line”. The Vue Red Line includes the same 250 hp (186 kW) Honda J35A3 V6 as the regular model, but with sportier suspension tuning, lowered 1 inch, and unique power steering calibration for performance, 18 in alloy wheels,…
What kind of engine does the Saturn Vue have?
This V-6 engine was used in the Saturn Vue 2004 to 2007 model years. 5- and 4-speed automatic transmissions return for 2005, and the CVT is dropped. All Vues get a redesigned interior critique with new air vents, new steering wheel, and a new radio faceplate which contributes noise, vibration, and harshness.
When did GM stop making the Saturn Vue?
The four-cylinder Vue was available with the VTi continuously variable transmission (CVT) until GM canceled it for 2005 due to dependability issues. The Vue received a facelift for the 2006 model year. Upgrades included a redesigned interior with higher-quality materials, a new bumper and grille, and some minor cosmetic pieces to the exterior.