Can a Kawasaki Prairie 650 4×4 be repaired?
I completely sank my Kawasaki prairie 650 4×4. I’ve changed the plug and plug wires, got any water out of the fuel tank, changed the oil several times and a new fuel filter and clean and dried the air filter, it still wont crank. Cdi box get wet ? kawasaki 2004…
What to do if your Kawasaki MULE 610 has a leak?
Gear driven internally. You must have a big leak on the intake system. look for a vacuum hose that has been disconnected or cracked. Some times you can find it by spraying wd-40 around the intake and if the idle changes that is where the leak is. I completely sank my Kawasaki prairie 650 4×4.
What do I need to know when my ATV wont start?
Activate the starter. You should see repetitive bright blue spark arching from the spark plug to the cylinder head as the motor turns. You will find the proper steps for troubleshooting an ATV that is not getting a spark further down this post.
What causes a Kawasaki ATV to run out of gas?
The needle and seat in the carb may be dirty/clogged/sticking and not allowing a full flow of fuel into the float bowl.. when the bowl fills, it will run fine for about 20 – 45 seconds then “run out of gas.. it will restart and repeat this over and over. 2.
What should I do about my Prairie 650?
For newer models, clean and lubricate the choke plungers or replace as necessary. 8) Stock ’02 Prairie 650 rear secondary clutch tends to wear out pre-maturely/causes significant decrease in top-speed; Fix: Replace with ’03 Prairie 650 or later secondary clutch.
How to fix a prairie 650 jet ski?
Fix: Don’t use the ATV as a jet ski. 4) 4wd actuator aluminum block severly worn and no longer engauges 4wd. Fix: remove the shaft it rides on, machine tap a screw into it and replace with a nylon roller and a washer to hold the roller on..
Are there any recalls on the Prairie 650 / 700?
13) Pre-2005 Prairies had a recall on the steering knuckles b/c the original knuckles were prone to breaking; Fix: Contact the local Kaw. dealership to make sure your Prairie 650/700 had the recall work done. You can also look at the knuckle and tell if its been updated or not.
What are common mechanical problems of Prairie 650 / 700?
Chokes tend to get sticky causing flooding.lots of cam’s have been ruined by this.polish the plungers and lube them to prevent this. Stumper, I agree…but I think I have that covered in item #7 on the above list.