How long does the igniter stay on when the burner is on?
The igniter will remain on for a specific amount of time (seconds) depending on the specific ignition module being used. This “on” time or trial for ignition time can vary, depending on the specific ignition module being used. When main burner ignition occurs, the flame is sensed by the igniter (local sense) or by a remote sensor (remote sense).
When does the igniter activate on a prepurge engine?
If the module is a prepurge model, it will delay 15 or 30 sec before the igniter is activated. On prepurge models, the module will energize the combustion blower or other relays at the beginning of the cycle.
Can you replace a CDI box at Rick’s Motorsport?
Rick’s Motorsport Electrics, Inc offers both OEM style and Hot Shot Series aftermarket replacement CDI boxes. The only real way to test your CDI box is to swap it out with another known good unit from the same year/make/model. Because of this, we recommend that you rule everything else out before replacing the CDI box.
Where does the CDI box amplify the signal?
The box amplifies the small signal generated from the spinning magnet located in front of the pickup coil in the stator, just before top dead center (TDC), when your fuel-air mixture is ignited. The box can’t generate continuous sparks.
Do you need a different ignition box for a zx9r?
You need an engine from a ’94-’97 ZX9R. Post ’97 ZX9R engines will not fit as the engine mounts are very different! The wiring harness of the ZX9R is pretty much identical to that of the 750, but you do need the ignition box of the ZX9R as the 900 motor does not rev as high as the 750 (hence you could blow it up if you use the 750 box).
Can a zx9r be used on a post 97 Kawasaki 750?
Post ’97 ZX9R engines will not fit as the engine mounts are very different! The wiring harness of the ZX9R is pretty much identical to that of the 750, but you do need the ignition box of the ZX9R as the 900 motor does not rev as high as the 750 (hence you could blow it up if you use the 750 box).
Can a 9R engine be converted to a ZX7R?
An alternative may be to use the oil plate that comes as part of the BRG conversion kit (the rest of the kit is only needed if trying to fit a 9R engine into a ’96 on ZX7R). You will notice that the upper mounts do not line up. This is because the stroke on the 9’s motor is 10mm taller.
Can a 93 / 95 Kawasaki ZXR750 airbox be converted?
On ’93/95 bikes the original airbox will fit, though depending on the carbs you use you may need the carb-to-airbox adapter plate from the ZX9R. The ’91/92 (J/K) airbox will fit, but is also likely to require a fair amount of modification to flow enough air for the 900cc motor.