Can a key fob be used to start a bike?
You are not going to believe this – but – it was the battery in the key fob. The bike has to have a signal from the key fob before it will allow the bike to start. The TSSM is the – turn signal security module ( Japan & Korean markets only) I asked the dealer is they could test the ECM and they said yes if it on the bike.
What kind of engine does a 2010 Harley Davidson have?
2010 Harley-Davidson® FLHTK – Electra Glide® Ultra Limited, VANCE AND HINES EXHAUST, KENWOOD AUDIO, CHROME DASH TRIM, ABS, SECURITY, CRUISE CONTROL,… ONLY 3,070 MILES. Like new, 2010 Harley Davidson Electra Glide Limited. Blue/Black, One owner, garage kept.
Why does my Harley Davidson bike not start?
If you can start the bike this way; the start switch is probably bad, or a wire may be damaged. Let us know what you find. Sounds like you know what you are doing. You are not going to believe this – but – it was the battery in the key fob. The bike has to have a signal from the key fob before it will allow the bike to start.
Why does my 1999 Road King not start?
I haveA 1999 road king have not rode it in about three years ,gas tank had treatment ,has been started and ran fine however tried to start, will start with choke on. Sprayed carburetor with carb cleaner still starts only on choke ,goes off when choke is taken off. I appreciate the post for valuable information.
What is the FOB on a Harley Davidson?
One more quick note regarding the new Smart FOB on Harleys made 2007 and later. As you probably know, these smart alarm FOBs are proximity FOBs, meaning anytime they are within about 6 feet of the bike your security system is disarmed.
What does a red key light on a Harley Davidson mean?
If the security light (the key) stays on solid (not flashing) and the bike starts and runs, it means the bike has thrown a DTC. (diagnostic trouble code) It is essentially the equivalent of the “check engine” light on a car. The procedure for checking the code is posted in the electrical section.
You are not going to believe this – but – it was the battery in the key fob. The bike has to have a signal from the key fob before it will allow the bike to start. The TSSM is the – turn signal security module ( Japan & Korean markets only) I asked the dealer is they could test the ECM and they said yes if it on the bike.
Why does my Dyna FXDC bike not start?
Alarm, clutch inhibit & neutral safety all come from the TSSM. The TSSM controls the start relay. 09 Dyna FXDC, got power everywhere. Lights,Horn,Turn`s,Fuel Pump,Dash, Turn the key on, hit the run/stop switch, push the start button and Nothing. Not even a click or a buzz. Bike has been sitting for about 2 weeks.
Why is the start button not working on my Harley Davidson?
If you did NOT read 12 volts, you would have to go back to the TSSM and hot wire (bypass it) in order to determine where the problem was. Also testing the start button would be something to check also. The key point to remember is that the “Start Relay Control” comes from the TSSM.
Can a unworn key turn an ignition cylinder?
Or, an unworn key may not turn a worn ignition cylinder, as they haven’t “worn together.” How To Fix It: The best way to do this is to get a new lockset, with new keys and a new cylinder. You might consider getting a matched lockset that includes the door and trunk cylinders.
How to start a bike without a fob?
Here is how to use the code you jus entered to start your bike without the Fob present!! 1. Turn the IGN key to IGNITION and immediately hold both turn signal switches until 5 dashes appear in the odometer window. 2. Enter the first digit of your PIN (a) by pressing the left turn signal switch (a) times.
When I turn on the bike and put it in the run position, the fuel pump kicks on, but when I push the start switch the bike doesn’t even try to turn over. The battery is fully charged and the fuel pump turns on when I push the switch, but nothing else happens.
Can a bad ignition coil cause a motorcycle to stall?
Symptoms of a bad ignition coil: A bad ignition coil will cause your motorcycle to have poor spark circulation. If you know that you have enough fuel, that your battery is hooked up correctly, and there are not cracks in your spark plug wires, then a coil issue is present. Poor idling and stalling will lead up to this problem.
How to turn off the FOB on a Harley Davidson?
Here’s how to do it!! 1. Select 5 digit code ( each digit being a 1 thru 9) and record it on the wallet card in the owners manual. 2. With an assigned FOB present, turn IGN key ON – OFF – ON – OFF – ON 3. Press Left turn signal switch 2 times. 4. Press Right turn signal switch one time and release.