Can a water pump blow a head gasket?
It is very possible that the head gasket was already leaking prior to the water pump being replaced. If the water pump has been replaced and you are still losing coolant then there is a great likelihood that the head gasket is blown.
Can a broken head gasket be replaced with a new one?
If you were simply to replace the broken head gasketwith a new gasket your engine would still not be sealed properly as the pits and warping of the engine block or head would still allow coolant to leak past the new gasket.
How to tell if your head gasket is blown?
How to tell if your car’s head gasket is blown DIY with Scotty Kilmer. How to tell if your head gasket is leaking and needs repair. How to test engine head gasket by using this simple leak test kit. DIY car repair with Scotty Kilmer, an auto mechanic for the last 42 years. 1. Bluetooth Scan Tool: http://amzn.to/2nfvmaD 2.
Where does the coolant go after blowing the head gasket?
Coolant either leaks past the head gasket out of the engine or past the head gasket into the cylinder and combustion chamber. If you have an external leak you will notice coolant leaking from in between your engine block and the head. This usually will happen just below the exhaust manifold or the intake manifold.
How can I tell if my water pump head gasket is defective?
Remove one spark plug wire at a time from its spark plug while monitoring the needle on the pressure gauge. If the needle on the gauge steadies with the spark plug wire removed, the head gasket for that cylinder head is defective.
When to replace the head gasket on a car?
If the needle fluctuates rapidly, the cylinder head gasket is defective and must be replaced. If the engine is equipped with two cylinder heads, it will be necessary to determine which of the two head gaskets is defective. Remove one spark plug wire at a time from its spark plug while monitoring the needle on the pressure gauge.
How can you tell if your water pump is leaking?
Pay particular attention to the area where the lower radiator hose connects to the bottom of the water pump, and to the area where the heater hose connects to the pump. If either area is wet, tighten the clamp that secures the leaking hose to the water pump with a screwdriver.
How is a water pump attached to a radiator?
Attach a cooling system pressure pump to the radiator cap opening on the radiator . The pump features a single hose and a gauge. The end of the hose attaches to a metal fitting, which looks similar to a radiator cap. Twist the fitting onto the radiator cap opening.