Where are the radar sensors on a Mercedes Benz?
The Mercedes assistance system can help drivers to change lanes safely: short-range radar sensors housed on both sides of the rear bumper monitor the areas directly alongside and behind the car.
How do you clean the radar sensor on a Mercedes?
Use soapy water to clean your sensors just like you would wash your car, taking extra care not to scratch the covers over your camera lenses. Damage from road debris like sand, rocks or other impacts can permanently damage your radar sensors, cameras and other components.
What does clean radar sensor mean?
The ACC “Clean Radar Sensor In Front Of Vehicle” warning will display when conditions temporarily limit system performance. This most often occurs at times of poor visibility, such as in snow or heavy rain. The ACC system may also become temporarily blinded due to obstructions, such as mud, dirt or ice.
Where is the radar sensor on a Mercedes?
The front right radar sensor is right next to the tow hook. Don’t install a tow hook license plate holder and mount your license plate here as this will hinder the performance of the radar sensor mounted right behind it. Depending on the options on your Mercedes, you will have cameras and sensors on various locations.
When to replace NoX sensor on 2016 BlueTEC?
2016 BlueTec, took delivery on Nov. 2015. Did DIY engine oil change on Nov. 2016 using Valvoline 5W-40 MST. Had a first CEL with fault codes P229F, P2201 in Aug. 2017 at 6.4K miles. Took to dealer, replaced both NOx sensor under warranty.
What to do if your radar sensor malfunctions?
Use window cleaner to rime any dirt. Also, inspect this part of the windshield for any rock chips. Rock chips in the part can cause these sensors to malfunction. Keep the bumper sensors clean at all times. These sensors can get dirty very easily. Use a clean cloth to remove dirt and grime for the sensors.
When was the NoX sensor replaced on my Mercedes?
The dealer says the NOx sensor replaced 2 months ago are not “taught”, they just “taught” both sensors today, and cleared the codes and called it done. Any one had to “teach” their replacement NOx sensors?