When to replace a door lock actuator cable?
Often, the cable that connects the door lock actuator to the inner door handle may be built in into actuator assembly. If the cable breaks and it’s not sold separately, the whole door lock actuator may also need to be replaced. See the example of a broken door lock cable.
How to replace the Mercedes-Benz interior door handle C?
The interior door handle of Mercedes C-Class W204 and GLK X204 are prone to breaking. There is no need to replace the entire trim as commonly suggested by the Mercedes-Benz dealer. Save time and money by just replacing the handle. eBay Store: http://stores.ebay.com/IE-Works?_dmd=… Visit our store: https://www.ieworksusa.com/collection…
How does a door lock actuator work on a car?
A door lock actuator is the component in electronic door locks that is responsible for locking and unlocking the vehicle’s doors. When a button is pressed to lock or unlock a door, the door lock switch triggers the actuator.
What do I need to repair a Mercedes door lock?
2. You will need a torx driver with at least a 4 inch shaft to get to the torx screw for the door handle removal. 3. Buy a set of nylon trim and molding removal tools. It will help get the panels off without scratching the panels or the paint.
How to replace the door lock actuator on a Mercedes Benz?
The first step in replacing the door lock actuator is to disconnect the battery. Remove the small plastic plate at the bottom of the rear passenger seat. Underneath is a 11mm nut holding the negative terminal from the battery to ground. Remove the nut and pull the cable off.
What to do if your door lock actuator is not working?
Sitting in the car with the doors shut, press on the locking switch of the affected door lock actuator. Then operate the inside door handle and open the door. If the door lock actuator is operating correctly, opening the interior door handle will override the door lock actuator.
How to replace door lock on Mercedes W210?
Remove the hook on the end of the inner door handle cable from the old door lock actuator. Pull the gasket out of the channel on the rear of the door. You want to find the small access hole inside the channel. This will allow you to access the small 4mm Allen bolt that retains the IR sensor/Door handle (green arrow).
How to replace the actuator on a Mercedes W210?
The first step in replacing the actuator is to disconnect the battery. Remove the small plastic plate at the bottom of the rear passenger seat. Underneath is a 11mm nut holding the negative terminal from the battery to ground. Remove the nut and pull the cable off. Remove the screw holding the door latch cover in place.