How do I install a new speedometer?

How do I install a new speedometer?

Part 1 of 2: Removing the old speedometer

1. Materials Required.
2. Step 1: Remove the negative battery cable.
3. Step 2: Remove the instrument cluster.
4. Step 3: Access the speedometer.
5. Step 4: Remove the speedometer from the instrument cluster.
6. Step 1: Install the new speedometer into the cluster.

Is it possible to replace a speedometer yourself?

Replacing the speedometer can seem like a large job, but when broken down into steps, many are able to complete it themselves. If you have any questions along the way, you can always Ask a Mechanic. If this task seems like too much for you to do on your own, YourMechanic also performs speedometer service and repair.

Where is the speedometer cable on a car?

Please try again later. The speedometer cable is located on top of the transmission, and it sends an electrical signal into the computer of the car. Find out how a speedometer cable runs up and under the dash of the car with help from an ASE-certified technician in this free video on replacing speedometer cables.

Can a negative battery be removed from a speedometer?

The negative battery cable should be removed so there is no chance of electrical damage when working with the speedometer. Loosen the battery cable bolt and remove the negative battery cable. Set the cable aside so it can not touch the battery. Step 2: Remove the instrument cluster. Locate the screws holding the instrument cluster in place.

How do you repair a GM speedometer shaft?

Now slide the fork under the gauge base being sure the fork tines are going around either side of the shaft. Next, pry upwards on the gauge base by pressing down on the fork handle. Be careful not to scratch your face plate.

What should I do if my speedometer is not working?

Troubleshooting speedometer problems mostly call for a replacement of the speed sensor or cable, depending upon the vehicle. Both these repair jobs are simple to perform and can be done at home.

Where is the speedometer sensor on a car?

The speedometer sensor is located inside the transmission and attached to a driveshaft, which impacts multiple functions of the car. Due to this fact, it’s possible that the Check Engine Light will light up on the dashboard if a sensor problem is discovered by the vehicle’s CPU.

The negative battery cable should be removed so there is no chance of electrical damage when working with the speedometer. Loosen the battery cable bolt and remove the negative battery cable. Set the cable aside so it can not touch the battery. Step 2: Remove the instrument cluster. Locate the screws holding the instrument cluster in place.

Why does my speedometer keep bouncing between speeds?

Bouncing or jerking of speedometer In cases where the speedometer does not settle on any particular reading but keeps moving between speeds, it is almost always due to bad wiring, in case of a cable system, or a faulty speed sensor. In most cases, only the wiring needs to be changed, or the sensors re-calibrated, to repair the problem.