How do you put brakes on a Kia Optima?
How to Change the Disc Brakes in a Kia Optima
- Vehicle Preparation. Park the vehicle on level ground and turn off its ignition. Open and secure the hood.
- Brake Removal. Remove the two bolts holding the caliper to its mounting bracket with a ratchet and socket.
- Brake Installation. Mount the new rotors on the axle.
How to replace the rear disc brake on a Kia Optima?
Repair procedures – Brake System – Brake System – Kia Optima TF 2011-2020 Service Manual 1. Remove the rear wheel & tire. 2. Connect the GDS to the data link connector located underneath the dash panel. 3. Ignition “ON” & Engine “OFF”. 4. Release the electric parking brake. 5. Select vehicle name and EPB system. 6.
How do you repair a Kia Cee’d disc brake?
Place the caliper body (A) on the caliper carrier and tighten the guide rod bolts (B). Assemble the caliper body so that the piston groove (A) is in-line with the pad center lobe (B). * Make sure that the piston and pad are tightly attached.
How do you change the EPB on a Kia Optima?
2. Connect the GDS to the data link connector located underneath the dash panel. 3. Ignition “ON” & Engine “OFF”. 4. Release the electric parking brake. 5. Select vehicle name and EPB system. 6. Select the “PAD change mode (Before pad change)”. 7. Perform the ” PAD change mode (Before pad change)” procedure with GDS.
Repair procedures – Brake System – Brake System – Kia Optima TF 2011-2020 Service Manual 1. Remove the rear wheel & tire. 2. Connect the GDS to the data link connector located underneath the dash panel. 3. Ignition “ON” & Engine “OFF”. 4. Release the electric parking brake. 5. Select vehicle name and EPB system. 6.
Place the caliper body (A) on the caliper carrier and tighten the guide rod bolts (B). Assemble the caliper body so that the piston groove (A) is in-line with the pad center lobe (B). * Make sure that the piston and pad are tightly attached.
2. Connect the GDS to the data link connector located underneath the dash panel. 3. Ignition “ON” & Engine “OFF”. 4. Release the electric parking brake. 5. Select vehicle name and EPB system. 6. Select the “PAD change mode (Before pad change)”. 7. Perform the ” PAD change mode (Before pad change)” procedure with GDS.