How to replace a crankshaft sensor for a Jeep Liberty?
Reconnect the electrical connector to the crankshaft sensor, then reconnect the negative battery cable if you disconnected it, tightening the cable’s clamp nut with the wrench. Chris Moore has been contributing to eHow since 2007 and is a member of the DFW Writers’ Workshop.
How do you install a new crankshaft on an engine?
Installing the New Crankshaft. Install the bearing caps in their correct places on the engine block. Make sure the numbers on the caps run consecutively from the front to the rear of the engine and the arrows on the caps point to the front of the engine. Install the bearing-caps mounting bolts finger-tight.
How do you change the bearings on a crankshaft?
Coat the crankshaft journals as well. The journals are the area on the crankshaft where the bearings will be resting on. Lay the crankshaft carefully on the engine block with the help of an assistant. Install the other half of the new bearings on the main bearing caps.
What should I use to grease the crankshaft?
Coat with a thin layer of moly-base grease the faces of the new main bearings you installed on the engine. Coat the crankshaft journals as well. The journals are the area on the crankshaft where the bearings will be resting on.
Reconnect the electrical connector to the crankshaft sensor, then reconnect the negative battery cable if you disconnected it, tightening the cable’s clamp nut with the wrench. Chris Moore has been contributing to eHow since 2007 and is a member of the DFW Writers’ Workshop.
Installing the New Crankshaft. Install the bearing caps in their correct places on the engine block. Make sure the numbers on the caps run consecutively from the front to the rear of the engine and the arrows on the caps point to the front of the engine. Install the bearing-caps mounting bolts finger-tight.
Coat the crankshaft journals as well. The journals are the area on the crankshaft where the bearings will be resting on. Lay the crankshaft carefully on the engine block with the help of an assistant. Install the other half of the new bearings on the main bearing caps.
How do you attach a pulley to a crankshaft?
Tap the crankshaft ends forward and backward 10 times with a brass hammer and retorque the main bearing caps with the torque wrench and short socket. Install the crankshaft pulley bolt at the front of the crankshaft finger-tight and rotate the crankshaft several times to check for binding.