How do I reset the oil change on my Jeep Liberty?
Reset service light indicator, engine oil life Jeep Liberty, oil reset instructions:
- Turn the ignition to run (one position before starting engine).
- Fully depress the accelerator pedal slowly three times within 10 seconds.
- Turn the ignition off and then start the engine to verify the indicator has been reset.
What kind of oil does a 2009 Jeep Liberty take?
Castrol Edge Synthetic Motor Oil 5W-20 1 Quart.
How many quarts of oil does a 2009 Jeep Liberty take?
Jeep Liberty 3.7L 2009, SAE 5W-20 Full Synthetic Motor Oil, 1 Quart by Idemitsu®….What kind of oil does a 2009 Jeep Liberty take?
| Capacity (Quarts) | Type | |
|---|---|---|
| Engine (2.8L Diesel) | 6.40 QUARTS | 5W40 or 0W40 |
How do you change the oil on a Jeep Liberty?
For most Jeeps, you can wrap an old belt around the oil filter and unscrew it by hand. If you can’t do this, see our parts page to find a Jeep Liberty oil filter wrench. If your Liberty is too low to the ground to access your drain plug and oil filter, be sure to use jack stands and safe jacking procedures before getting under your Liberty.
Where is the oil filter on a Jeep Liberty?
Raise the front of the vehicle with the floor jack and securely support it with at least two jack stands. Slide underneath the vehicle and locate the black metal oil pan with the 13mm oil drain bolt facing towards the rear. The cylindrical oil filter is located next to the oil pan. Move the used oil catch container to just below the oil drain bolt.
What kind of engine does a Jeep Liberty have?
Owners of other Jeep, Dodge, Mitsubishi or Chrysler vehicles with the PowerTech 3.7 liter EKG engine such as the Grand Cherokee, Commander, Nitro, Ram 1500, Dakota, Durango, M80 and Raider may also find these oil change instructions to be helpful.
How do you fix a leaking oil filter?
Replace Filter – Add oil to the new oil filter and insert it 8. Remove Oil Cap – Take off the oil fill cap 9. Add Oil – Determine the correct oil type and add oil 10. Replace Cap – Put the oil fill cap back on the engine 11. Leak Inspection – Start vehicle and visually inspect for leaks 12.
For most Jeeps, you can wrap an old belt around the oil filter and unscrew it by hand. If you can’t do this, see our parts page to find a Jeep Liberty oil filter wrench. If your Liberty is too low to the ground to access your drain plug and oil filter, be sure to use jack stands and safe jacking procedures before getting under your Liberty.
Raise the front of the vehicle with the floor jack and securely support it with at least two jack stands. Slide underneath the vehicle and locate the black metal oil pan with the 13mm oil drain bolt facing towards the rear. The cylindrical oil filter is located next to the oil pan. Move the used oil catch container to just below the oil drain bolt.
Owners of other Jeep, Dodge, Mitsubishi or Chrysler vehicles with the PowerTech 3.7 liter EKG engine such as the Grand Cherokee, Commander, Nitro, Ram 1500, Dakota, Durango, M80 and Raider may also find these oil change instructions to be helpful.
Replace Filter – Add oil to the new oil filter and insert it 8. Remove Oil Cap – Take off the oil fill cap 9. Add Oil – Determine the correct oil type and add oil 10. Replace Cap – Put the oil fill cap back on the engine 11. Leak Inspection – Start vehicle and visually inspect for leaks 12.