Why does my Jeep Cherokee make a grinding noise?
It was definitely a grinding noise that was speed dependent, definitely coming from the brakes. I got back from the service department this morning (Flemington Jeep in NJ has a great service department FWIW), and the mechanic showed me two areas on the left front rotor that were scraped.
Why does my car make a grinding noise when I stop?
I was luckily about a block away from work so I just drove to the parking lot. The noise only occurs when the car is moving, even slightly, and stops when I stop. My stopping power feels the same, no shaking or shuddering.
What kind of noise is a grinding noise?
Horrible grinding noise. Well this morning did not start off so well. I was on my way to work when I stopped at a stop light, when I started to go again I heard a bad grinding noise (loud and constant).
It was definitely a grinding noise that was speed dependent, definitely coming from the brakes. I got back from the service department this morning (Flemington Jeep in NJ has a great service department FWIW), and the mechanic showed me two areas on the left front rotor that were scraped.
Are there any problems with the Jeep Grand Cherokee?
Jeep Grand Cherokee owners have reported 27 problems related to transmission noise (under the power train category). The most recently reported issues are listed below. Also please check out the statistics and reliability analysis of Jeep Grand Cherokee based on all problems reported for the Grand Cherokee.
What makes a Jeep Grand Cherokee stall at 72 mph?
The contact stated that while driving at 72 mph, there was an abnormal bang noise causing the vehicle to stall. The vehicle was able to restart. The vehicle was taken to tallahassee Dodge Chrysler Jeep ram fiat 3987 w tennessee st, tallahassee, FL 32304 (844) 280-9221 where it was diagnosed that the transmission needed to be replaced.
Where can I get a Jeep Grand Cherokee transmission replaced?
The vehicle was taken to tallahassee Dodge Chrysler Jeep ram fiat 3987 w tennessee st, tallahassee, FL 32304 (844) 280-9221 where it was diagnosed that the transmission needed to be replaced. The vehicle was not repaired. The manufacturer was not notified of the failure. The approximate failure mileage was 3,300. Ak.
What’s the grinding noise in the front end?
Jeep Grand Cherokee Questions – whats the grinding noise in front end. – CarGurus whats the grinding noise in front end. drives fine, front grinding gets louder as I accelerate.
Can a bad wheel bearing cause a Jeep Grand Cherokee to lock up?
It is not recommended to drive your Jeep Grand Cherokee on a bad wheel bearing. They are dangerous. As they go bad they create heat. This heat can eventually cause the tire to lock up while going down the road. Replacing a wheel bearing is not that expensive, even if you take it in to a shop. Good luck diagnosing your Grand Cherokee.
Why does my Jeep make a whine while driving?
The dealer told me that the SRT8 wheels are the cause of the problem.. Oh well, tough shit, Im not taking them out.. LOL They were provably short on oil in one of the diffs, i know that’s how i got my whine out back and now my rear yoke bearing needs replacement. Click to expand…
https://www.youtube.com/watch?v=G6n8U2ekS_s
Why does my Quadra Drive make noise when turning sharp corners?
This only applies to the 247 Transfer case found in Quadra Drive and Quadra Trac II grand cherokees. T-case: Low fluid level, improper type of fluid, and old/dirty fluid can cause the progressive coupler to engage and chatter while turning sharp corners, such as in a mall parking lot.
How to fix np247 and Quadra Drive noise?
4. Fill it. Put half of the limited slip additive into the first bottle of t-case fluid (easier to get it in there) and dump the whole quart in. You will only need to use about 3/4 of the next bottle, fill the case until the fluid starts to come out of the fill hole.
What can I do to quiet down Quadra Drive?
A fluid change and limited slip additive in the axles if you have Quadra Drive or the optional vari-lok rear can really quiet things down. Change the fluid in the axles. Use 75-140w synthetic gear lube, and add a 4oz bottle of mopar limited slip additive in each axle.
Why does my Jeep Grand Cherokee make a grinding noise?
I had a metal grinding noise on my 2006 Jeep Grand Cherokee that I thought was a wheel bearing going out. It was making the noise mostly when accelerating but not on braking or when in neutral. I found the problem to be a CV joint that is on the prop shaft that links the transfer case to the front axle. Loading…
This only applies to the 247 Transfer case found in Quadra Drive and Quadra Trac II grand cherokees. T-case: Low fluid level, improper type of fluid, and old/dirty fluid can cause the progressive coupler to engage and chatter while turning sharp corners, such as in a mall parking lot.
Jeep Grand Cherokee Questions – whats the grinding noise in front end. – CarGurus whats the grinding noise in front end. drives fine, front grinding gets louder as I accelerate.
4. Fill it. Put half of the limited slip additive into the first bottle of t-case fluid (easier to get it in there) and dump the whole quart in. You will only need to use about 3/4 of the next bottle, fill the case until the fluid starts to come out of the fill hole.
What should I do if I hear a thumping noise on my brakes?
Do this three to five times, while keeping a steady speed; the noise should disappear, or at least be 90% gone. Then drive the car at normal speeds and use the brakes the way you normally would. If the noise has not changed, you may have a different thumping noise than what I have described here in this article.
Why does my accelera make a grinding noise?
If the noise increases with road speed, whether accelerating or coasting, it is more likely a wheel bearing.
What kind of noise does your car make when you apply the brakes?
Other Noises That May Not Be Related to Your Brakes 1 Grinding Noise When Brakes Are Applied Hearing a grinding noise when you apply your brakes is really like hitting a… 2 Thumping Noise From the Rear When Braking This brake issue is one that will annoy the heck out of the driver and suck… 3 Squeaking Noise While Breaking or Driving More
Why does my car make a clicking noise?
Constant-velocity joints (also known as CV joints) are what connects the transmission to the wheels. They are used primarily on front-wheel-drive vehicles. If your car makes noise when accelerating at low speeds and taking a tight turn (usually a clicking, knocking, or grinding sound), it is likely failing.
Do this three to five times, while keeping a steady speed; the noise should disappear, or at least be 90% gone. Then drive the car at normal speeds and use the brakes the way you normally would. If the noise has not changed, you may have a different thumping noise than what I have described here in this article.