When does the clutch go in, the whine goes away?
When the clutch is in, the sound goes away, when it’s out you can hear it run. If you ‘ride’ the clutch just a little bit you can get it to whine at a different pitch. The sound would be louder after the car had been driven for a while, say for 20 minutes on a freeway, then everything would be hot and it would get loud.
What happens when you push the clutch to the floor?
You may need to pull the driveshaft and tranny to get a good inspection. While you are in there it’s probably a good idea to do the clutch and pressure plate as well …… When you push the clutch to the floor , all the gearing within the transmission stops turning . You are hearing the gear train spinning from your description
What makes a rattling noise when the clutch is pushed?
Rattle was the clutch release bearing, took two dealerships and a lot of heated conversations to get it warrantied at 47K miles. There was no abnormal noise when I bought the truck about a year ago.
What happens when you release the clutch pedal?
If your clutch release bearing is going out, you may also notice a whirring or chirping sound that goes away when you release the clutch pedal. The push rod connects the top of the clutch pedal to the piston inside the master cylinder.
When the clutch is in, the sound goes away, when it’s out you can hear it run. If you ‘ride’ the clutch just a little bit you can get it to whine at a different pitch. The sound would be louder after the car had been driven for a while, say for 20 minutes on a freeway, then everything would be hot and it would get loud.
What to do if your clutch pedal is too stiff?
Once the clutch is disengaged, you can shift the gears of the transmission safely. But if the clutch cable is stretched too much or broken, then you will have to press down harder on the clutch pedal to disengage the clutch.
You may need to pull the driveshaft and tranny to get a good inspection. While you are in there it’s probably a good idea to do the clutch and pressure plate as well …… When you push the clutch to the floor , all the gearing within the transmission stops turning . You are hearing the gear train spinning from your description
Why does my CRB make noise when I Dip the clutch?
A failing (or failed) CRB will tend to make noises only when you dip the clutch. Yup. Rattling lay shaft or idle gear shaft is a common 5 speed box ‘noise’. It does not signify that anything is about to fail. It is a “they all do that sir” noise.
What makes a knocking noise when the clutch is depressed?
Rev or depress clutch and it goes away. I’d plump for a rattly gearbox layshaft too, especially if raising the idle speed slightly or dipping the clutch calms things down — a case of TADTS and nothing to worry about. A failing (or failed) CRB will tend to make noises only when you dip the clutch. Yup.