How do you remove ball joints on a Jeep XJ?

How do you remove ball joints on a Jeep XJ?

1. Step 1 – Raise and support the front of the vehicle.
2. Step 2 – Remove the wheel(s)
3. Step 3 – Remove the axle nut.
4. Step 4 – Remove the caliper from the rotor.
5. Step 5 – Remove the rotor/drum from the hub.
6. Step 6 – Remove the wheel hub and axle.
7. Step 7 – Remove the spindle from the ball joints.
8. Step 8 – Press out the ball joints.

How do you remove the ball joint from a lawn mower?

Removing the Old Ball Joint Pull the cotter pin and loosen the large castellated nut. The top should look like a crown, or castle, at the bottom. Pop loose the ball joint. The goal is to try to guide it through the hole in the upper half of the steering knuckle. Remove the allen bolts and slide the control arm free.

How do you know if ball joints need to be replaced?

Inspect the ball joints to make sure they need to be replaced. Figure out if your vehicle’s got a strut-style suspension or a control arm, then check the ball joint by either jacking up the control arm near the ball joint to check for wheel play, or by jacking up the car and using a pry-bar to check for wheel play in a strut-style suspension.

How do you put a new ball joint in a car?

Slide the new rubber boot over the ball joint’s stud and guide the new ball joint back up through the steering knuckle hole, where it came from. Bolt the joint into place using the hardware included.

How much grease do you need to replace ball joints?

Generally, the specs will be about 44 pounds per foot on the screws and around 80 for other bolts. Always defer to the owner’s manual for accurate numbers, however. Screw in the new grease fitting and pump grease into the assembly. If you removed the brake or wheel, reattach them and lower the vehicle back down to test out the action.

How to replace a Jeep Cherokee ball by a girl?

Jeep Cherokee Ball Joint Replacement- By a Girl! – YouTube Jeep Cherokee Ball Joint Replacement- By a Girl! If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.

What’s the best way to replace a ball joint?

Screw in the new grease fitting and pump grease into the assembly. If you removed the brake or wheel, reattach them and lower the vehicle back down to test out the action. Bleed the brakes, if necessary. It’s a good opportunity to do any other repairs you might need to do with the brakes, since you’ve got them off.

Removing the Old Ball Joint Pull the cotter pin and loosen the large castellated nut. The top should look like a crown, or castle, at the bottom. Pop loose the ball joint. The goal is to try to guide it through the hole in the upper half of the steering knuckle. Remove the allen bolts and slide the control arm free.

Generally, the specs will be about 44 pounds per foot on the screws and around 80 for other bolts. Always defer to the owner’s manual for accurate numbers, however. Screw in the new grease fitting and pump grease into the assembly. If you removed the brake or wheel, reattach them and lower the vehicle back down to test out the action.